User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
29
Appendix A
Tag Programming
This appendix describes how to program tags of varying protocols using CHUMP
commands sent from a terminal or console.
Information provided in this appendix includes the following:
• Overview of the Tag Writing Command
• Programming the EPC1 Tag
• Programming the ISO 18000-6A Tag
• Programming the ISO 18000-6B Tag
• Programming the Impinj EPC0 Tag
• Programming the Matrics Class 0+ Tag