User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
Configuring the IP Address
45
7. Select the IP address of the reader to configure.
NOTE: If the IP adress returns all zeros (0.0.0.0), configure the reader manually by
selecting Configure network settings.
8. The following steps require loading a Java applet onto your computer. If your
computer will accept applets, follow Step 10 through Step 13.
9. If your system cannot run Java applets, follow Step 14 through Step 17 to
complete the setup using a Telnet session to enter commands.
10. (For Java applet) Click on Open web interface to load a Java applet and open
a web browser window off the reader’s device server.
11. (For Java applet) Click Yes if you get a security dialog box request when the
applet launches.
Figure 18–Digi Device Discovery Web Interface Window
12. (For Java applet) Select Serial Ports and verify the Baud Rate is set to 57600.
Figure 19–Digi Device Discovery Serial Configuration Window
13. (For Java applet) Press Save and go to Step 18.