User's Manual

MP9310 User’s Guide
46
14. (For Telnet session only) Connect to the reader via a Telnet session. Use the
IP address returned by the Digi Discovery application and Port 23 for the
Telnet connection.
15. (For Telnet session only) Enter show serial and verify ther serial port
settings match the settings in the reader’s SCW configuration register.
16. (For Telnet session only) To change the baud rate, enter set serial
baudrate = <rate>
. For best performance, a baud rate of 57600 is
recommended.
17. Close the Telnet session.
18. Verify the serial port on the reader is connected to the serial port on your PC
or host system with a serial cable.
19. At this time, load RF Command Suite. This application is a SAMSys reader
management application supplied on your system CD. RF Command Suite
will be used to set the serial port speed on the reader to a Baud Rate of 57600.
20. If the reader’s serial port Baud Rate is not correct, you can modify the rate by
selecting the Reader Config interface window.
21. Expand Reader Configuration D General Configuration D Serial
Communications
D Serial Configuration Word (SCW).
Figure 20–Reader Serial Port Properties
22. Determine which UART is driving the serial port:
• UART-1 – unused
• UART-2 – RS-232
• UART-3 – Ethernet
23. Change any settings and click Send Changes to Reader .
24. After setting the Baud Rate, close any ConnectMe and Digi Device
Discovery windows.