User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
Configuring the IP Address
47
25. From RF Command Suite, select Reader Connection J Disconnect. This will
disconnect any auto connected sessions.
26. Select Reader Connection J Connect via TCP/IP.
27. Select Reader Connection J AutoConnect to establish an Ethernet
connection.
28. Select the IP address of the reader from the popup list and press OK.
29. Select the Command interface tab and press the Version function key to verify
communication with the reader.