Installation Manual

6
The MP9320 is factory calibrated for operation with the following type of antenna:
The following antenna cable type is suggested:
It is highly recommended that the antenna mounting be adjustable in order to obtain
the best performance from the system. However, the antennas must be installed on a
solid surface or frame to prevent damage or later misalignment. Perform the following
to install the antennas.
NOTE:Use the existing mounting holes on the antenna flange. Drilling new holes in
the flange is not recommended.
1. Determine the location of each antenna. Ensure the antenna(s) will not be
vulnerable to damage by moving inventory or equipment.
2. Use the antenna as a template and mark the mounting holes.
3. Drill and tap (if necessary) mounting holes for #10 or 1/4 inch mounting screws.
For drywall mounting, use drywall anchors or toggle screws.
4. Mount each antenna and install the mounting screws. Do not overtighten the
screws. Damage to the antenna case may result.
5. Route each antenna cable back to the reader location. For dual-opposing or
portal configurations, route the opposing cables so they can not be damaged by
equipment or personnel.
6. Secure each antenna cable with wire ties or other restraint.
Antenna Parameter FCC ETSI
Frequency 902-928 MHz 865-870 MHz
Polarization Circular Circular
Gain, dBic 8, max 5, max
Antenna power handling 1 W, minimum 1 W, minimum
VSWR, maximum 1.3:1 1.3:1
Cable Parameter Value
Type RG58C/U
Connector SMA type plug, reader side