User's Manual

Federal Communication Commission (FCC) Regulations

This module is intended for OEM integrator. The OEM integrator is still responsible for

the FCC compliance requirement of the end product, which integrates this module. Any

changes or modifications not expressly approved by the manufacturer could void the

user's authority to operate this equipment.

The OEM/integrator must test final product to comply with unintentional before

declaring compliance of their final product to Part 15 of the FCC Rules.

The CM105 has been certified for mobile and base radio applications. If the CM105 will

be used for portable applications, the device must undergo SAR testing.

A separate approval is required for all other operating configurations, including portable

configuration with respect to FCC 47 CFR 2.1093 and different antenna configurations. It

is the responsibility of the OEM to gain type approval for the host product.

The CM105 does not require any further shielding and therefore can be fitted into any

host product. The end-users of the product must be provided with transmitter/antenna

installation requirements and operating conditions to satisfy RF exposure compliance by

the integrator. The RF output is via a 50Ω SMA(RP-SMA female) connector.

The final end product must be labeled in a visible area with the following " Contains FCC

ID: 2AJRJ-CM105 ".

This transceiver works on frequencies which are not generally permitted. For frequency

allocation, apply for a license at your local spectrum management authority. For actual

usage contact your dealer or sales shop in order to get your transceiver adjusted to the

al-located frequency range.

Important Notice for North American Users Regarding 406 MHz Guard Band

Frequency band 406 - 406.1 MHz is reserved for use ONLY as a distress beacon by the

US Coast Guard and NOAA.

Under no circumstance should this frequency band be part of the preprogrammed

operating frequencies of this radio.