Programming Instruction

Dust Cyclone- Remote control panel function

SF-H01A

2022/01 V1.0

PROGRAMMING INSTRUCTION

FOR HANDHELD REMOTE CONTROL-ZF1530-K4S

Button A : ON button. Turns the cyclone ON, the Power indicator light will

illuminate.

Button B: OFF button. Turns the cyclone off, the Power indicator light will go off.

Button C: CLEAN button. Starts to clean cartridge filter, rotate clockwise (10s) and

anti-clockwise (10s) for a cycle.

Button D: RESET button. Press SW1 or Reset button from remote switch until you

hear two beeps. Press the RESET Button from handheld remote

control until you hear three beeps to complete the set up.

Warning

：

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that

may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment. This

equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency

B: OFF button

A: ON button

D: Reset button

C: CLEAN button

PAGE 1
SF-H01A Dust Cyclone- Remote control panel function PROGRAMMING INSTRUCTION FOR HANDHELD REMOTE CONTROL-ZF1530-K4S A: ON button B: OFF button C: CLEAN button D: Reset button Button A : ON button. Turns the cyclone ON, the Power indicator light will illuminate. Button B: OFF button. Turns the cyclone off, the Power indicator light will go off. Button C: CLEAN button. Starts to clean cartridge filter, rotate clockwise (10s) and anti-clockwise (10s) for a cycle. Button D: RESET button.
PAGE 2
Dust Cyclone- Remote control panel function SF-H01A energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.