Owner Manual

ManualsBrandsSand & Stable ManualsBathroom Vanity LightingBabson 4 - Light Dimmable Vanity Light

Page 1 of 1

Components

1. Mounting Screws

2. Mounting Bar w/Green Screw

3. Hex Nuts（8/32)

4. Outlet Box Mounting Screws

5. Fixture

6. Cylinder Nut

7. Socket Ring

8. Glass Shade

9. Socket

1. Find appropriate threaded holes on Mounting Bar (2), and assemble Mounting Screws (1) into threaded holes with Hex Nuts (3).

2. Attach Mounting Bar (2) to Outlet Box with Outlet Box Mounting Screws (4) in such a way that the 2 each 8/32 fixture mounting screws

(1) are in a horizontal location.

3. Raise Fixture (5) toward outlet box, then connect fixture ground wire to outlet box ground wire with wire connector supplied; connect

white fixture wire to the white power supply wire with wire connector supplied; connect black fixture wire to the black power supply wire

with wire connector supplied.

4. Push Fixture (5) canopy to wall, make sure mounting holes in Fixture (5) canopy and Mounting Bar (2) are in line, verify all wires are

securely inside fixture back plate, and then secure fixture to wall with Mounting Screws (1) and Cylinder Nuts (6).

5. Raise Glass Shades (8) over Sockets (9) onto glass holder of Fixture (5), then secure it with Socket Rings (7).

Assembly Instructions

Last Updated: 11/30/2017

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Important Safety information (Please read before proceeding)

1. Remove the fixture, parts and all mounting hardware bags (orange) from the carton and verify that all parts are present according to the illustration sheet. All parts

must be used as indicated. Do not replace any parts, leave any parts out, or use any parts which are worn out or broken. Failure to follow the instructions could

cause a hazardous situation, voids the warranty and violates the U.L. listing of the fixture.

2. To prevent the electric shock, turn off the main power at the circuit breaker before installing the fixture. NEVER attempt to install, clean or replace bulbs without

shutting off the electricity to the fixture.

3. Never use light bulbs with wattage ratings that exceed the fixtures maximum rating. Always make sure the electric current is turned off before changing the

bulbs.

4. If you experience difficulties installing the lighting fixture or it fails to work as expected, please contact a local qualified licensed electrical contractor.

5. Please contact your local Capital Lighting Fixture reseller with any assembly or installation questions. Your local reseller can also provide you with replacement parts

for your new fixture.

Summary of content (1 pages)

PAGE 1
Page 1 of 1 ASSEMBLY AND INSTALLATION INSTRUCTIONS Important Safety information (Please read before proceeding) 1. Remove the fixture, parts and all mounting hardware bags (orange) from the carton and verify that all parts are present according to the illustration sheet. All parts must be used as indicated. Do not replace any parts, leave any parts out, or use any parts which are worn out or broken. Failure to follow the instructions could cause a hazardous situation, voids the warranty and violates the U.