FCC Class B Test Report For A Class B Digital Device Client: SanDisk Corporation 7 Atir Yeda Street Kfar Saba, Israel Phone 972-9-7644908 Device Under Test: SanDisk SSD SATA 5000 2.5” Document Number: 2007160 Reference Number: QRTL07-033 This report may not be reproduced, except in full, without the written approval of Rhein Tech Laboratories, Inc.
Test Overview: Model No.: Manufacturer’s Name: Manufacturer’s Address: Manufacturer’s Contact: Type of Equipment: Serial No.: Year of Manufacture: Location of Testing: Date of Receipt: Date(s) of Testing: Purpose of Testing: SanDisk SSD SATA 5000 2.5” SanDisk Corporation 7 Atir Yeda Street Kfar Saba, Israel Eitan Chalfon ITE 713050010 2007 Rhein Tech Laboratories, Inc., Herndon, VA February 5, 2007 April 10, 2007 FCC Class B Compliance Standard(s) to which device was tested: STANDARDS CFR47 Parts 15.
60 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com TABLE OF CONTENTS 1 GENERAL INFORMATION ............................................................................................................................. 4 1.1 1.2 2 TEST DETAILS................................................................................................................................................ 5 2.1 2.2 2.3 2.4 2.5 3 DOC LABEL ON DEVICE......................................................
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 1 GENERAL INFORMATION The following test report for a Class B digital device is prepared on behalf of SanDisk Corporation in accordance with Part 2, and Part 15, Subparts A and B of the Federal Communications Commissions Rules and Regulations. The Equipment Under Test (EUT) was the SanDisk SSD SATA 5000 2.5”. The test results reported in this document relate only to the items that were tested.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 2 TEST DETAILS 2.1 PRODUCT DESCRIPTION SanDisk SATA 5000 2.5” SSD is a drop-in replacement for the hard disk drive. It has no moving/ mechanical parts. Features o 2.5" small form factor supporting unformatted capacity of 32GB o 9.5mm case height o SATA 7+15 pins combo connector Interface to host o Standards: SATA 1.0a 1.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 2.4 EQUIPMENT UNDER TEST Listed below are the identifiers and descriptions of all equipment, cables, and internal devices used with the EUT for this test. Equipment Under Test Part SATA Storage Device Manufacturer SanDisk Corporation Model SanDisk SSD SATA 5000 2.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 2.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 3 3.1 PRODUCT LABELLING/ INFORMATION TO THE USER DOC LABEL ON DEVICE The label shall be located in a conspicuous location on the device and shall contain the unique identification described in FCC CFR 47; Section 2.1074 (the unique model name), and the following DoC logo: SanDisk Corporation 3.2 SanDisk SSD SATA 5000 2.5” DOC STATEMENT IN USER’S MANUAL For a Class B digital device or peripheral, per FCC CFR 47; Section 15.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 4 4.1 CONDUCTED EMISSIONS SITE AND TEST DESCRIPTION The power line conducted emission measurements were performed in a Series 81 type shielded enclosure manufactured by Rayproof. The EUT was assembled on a wooden table 80 centimeters high. Power was fed to the EUT through a 50 ohm /50 microhenry Line Impedance Stabilization Network (EUT LISN). The EUT LISN was fed power through an A.C.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 4.2 CONDUCTED EMISSIONS TEST DATA Mode: 115 vac, 60 Hz. Neutral Conductor Emission Frequency (MHz) Test Detector Analyzer Reading (dBuV) 0.157 0.157 0.186 0.186 0.212 0.221 0.265 0.320 0.320 0.372 0.372 0.710 1.650 4.450 15.070 17.640 25.100 Qp Av Qp Av Qp Qp Qp Qp Av Qp Av Pk Pk Pk Pk Pk Pk 56.2 33.4 54.7 21.8 42.4 43.7 46.6 54.0 29.3 51.7 30.9 40.4 35.5 35.6 25.2 28.2 29.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 4.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 5 5.1 RADIATED EMISSIONS SITE AND TEST DESCRIPTION Before final measurements of radiated emissions were made on the open-field three/ten meter range, the EUT was scanned indoor at one and three meter distances. This was done in order to determine its emissions spectrum signature.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 5.2 FIELD STRENGTH CALCULATION The field strength is calculated by adding the Antenna Factor and Cable Factor, and subtracting the Amplifier Gain (if any) from the measured reading.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 5.3 RADIATED EMISSIONS TEST DATA Emission Frequency (MHz) Test Detector Antenna Polarity (H/V) 50.000 73.800 144.000 191.992 200.000 225.000 250.000 369.340 406.340 463.850 485.970 631.945 700.000 Qp Qp Qp Qp Qp Qp Qp Qp Qp Qp Qp Qp Qp H V V V V V H H V H V V V Temperature: 48°F Humidity: 36% Turntable Antenna Analyzer Site Emission Azimuth Height Reading Correction Level (deg) (m) (dBuV) Factor (dBuV/m) (dB/m) 200 3.0 38.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 5.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 6 EMISSIONS EQUIPMENT LIST The following is a list of equipment Rhein Tech uses to perform testing. Part Type Spectrum Analyzer (10kHz-1.5GHz) Spectrum Analyzer Display Section Quasi-Peak Adapter Filter 16A LISN 16A LISN Current Probe (Telecom conducted) Emissions testing software EMI Receiver RF Section, 9 KHz - 6.5 GHz RF Filter Section, 100 KHz to 6.
360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com 7 MANUFACTURER’S EQUIPMENT FILE CHECKLIST (PER FCC RULES §2.1075) This checklist shall be used by the manufacturer to verify the correct filing per FCC 2.1075 Retention of records for products produced and marketed. PRODUCT MODEL(s): Records Verified By: SanDisk SSD SATA 5000 2.5” A record of the original design drawings and specifications.