User's Manual

58
20070830_WFR-20_381R101-A_GB.p65 2007/9/6, ¤U¤È 05:1861
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the 
user’s authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the 
device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure 
requirements and void user’s authority to operate the device.The antenna used for this transmitter must be installed to 
provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with 
any other antenna or transmitter.
FCC INFORMATION
•The Federal Communication Commission Radio Frequency Interference. Statement includes the following paragraph:
•The equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause
harmful interference to radio communication. However, there is no grantee that
interference will not occur in a particular installation. If this equipment dose cause
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on , the user is encouraged to try to correct the 
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
The user should not modify or change this equipment without written approval
form SANGEAN ELECTRONICS INC. Modification could void authority to use this equipment.