User Manual

8

Operating your radio – Scan tuning AM/FM
1. Press the Power button to switch on your radio.
2. Press the Source button
to select AM or FM radio mode.
3. Press and hold the Tuning control
to carry out an auto-tune. Your radio will scan up the AM/FM band from the
currently displayed frequency and will stop scanning automatically when it finds a station of sufficient strength.
4. After a few seconds the display will update. The display will show the frequency of the signal found.
5. To find other station, press and hold the Tuning control
as before.
6. When the end of the waveband is reached your radio will recommence tuning from the opposite end of the
waveband.
7. Rotate the Tuning control to
adjust the sound level as required.
8. To switch off your radio press the Power button
.
 Whileadjustingthevolume,
makesuretheFM/AMisNOT
flashingonthescreen.
 IfAM/FMisflashingonthe
screen,itallowsyoutotune
thestationsmanually(seethe
sectionof’Manual
tuning‐AM/FM’formore
detail)