User Manual

9

Manual tuning – AM/FM
1. Press the Power button to switch on your radio.
2. Press the Source button
to select AM or FM radio mode.
3. Press the Tuning control
and you will see the FM or AM is flashing on the display.
4. Rotate the Tuning control
to tune to a station. The FM frequency will change in steps of 100kHz and AM
frequency will change in steps of 10kHz.
5. When the end of the waveband is reached your radio will recommence tuning from the opposite end of the
waveband.
6. Use the Tuning control
to adjust the sound level as required.
Presetting stations in AM/FM mode
There are 5 preset stations each for AM and FM radio. They are used in the same way for each waveband.
1. Press the Power button
to switch on your radio.
2. Press the Source button
to select the desired waveband. Tune to the required radio station as previously
described.
3. Press and hold the required Preset button (1 to 5)
until the display shows
“P4” for example after the frequency. The station will be stored using the preset number. Repeat this procedure for the
remaining presets as you wish.
4. Preset stations which have already been stored may be overwritten by following the above procedure if required.
 FM/AMwillflashapprox.10
seconds.Withinthisperiod,
onlymanualtuningisallowed
 Ifvolumeadjustmentis
desiredwhileFM/AMis
flashing,presstheTuning
controltostoptheflashand
youcanrotatetheTuning
controltoadjustsoundlevel.