User's Manual

4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be over written by following
above procedures.
Recall stations from preset memories
1. Press the Power button to turn on the radio.
2. Select the required frequency band by pressing the Band/Step button.
3. Momentarily press the required Preset button, the preset number
and station frequency will appear in the display.
Display backlight
When radio is switched on, press any button except Power button
will illuminate the LCD display for approx. 10 seconds.
Software version/Setting tuning step
Software version
The software display cannot be altered and is just for your reference.
1. When the radio is switched off, press and hold the Band/Step button 3
seconds until software version 'PXX' shown on the display.
Setting tuning step
Tuning step in some countries are different from where you purchase
the radio. If you buy the radio in Europe and intend to use in
Northern America or some Latin American countries, you may have
to adjust tuning step so the radio may continue to serve you well.
1. After the software version is shown on the display, continue pressing and
holding the Band/Step button until FM tuning step option appears and flashes
on the display. Then rotate the Tuning control knob to select 50 kHz or 100
kHz for FM radio. Press the Band/Step button to confirm the selection. Now the
AM tuning step option appears and flashes on the display
2. Rotate the Tuning control knob to select 9 kHz or 10 kHz for AM radio.
Press the Band/Step button to confirm the setting. The tuning step setting is
completed.
Note:
Adjusting the AM tuning step will erase your preset stations stored in the radio.
The AM memory presets will revert to factory default.