381QG01-A Operating instruction FM STEREO / AM / TV 19 MEMORY PRESETS PLL SYNTHESIZED RECEIVER DT-200VX
Limited Warranty Sangean America, Inc. warrants this product to be free from defects in material and workmanship under normal use and conditions for a period of 90 (Ninety) days from the date of original purchase on parts and labor. Should service be necessary for any reason due to manufacturing defect or malfunction during the warranty period Sangean America, Inc.
Any applicable implied warranties, including the warranty of merchantability, are limited in duration to a period of 90 (Ninety) days from the date of original purchase. No other warranties, whether expressed or implied shall apply to this product thereafter. Sangean America, Inc. is not liable for any loss or damage, direct or consequential arising out of the use of, or inability to use this product.
3
Headphone/Antenna Jack 1 Note: To improve reception during speaker use, leave headphones or external antenna device plugged in through earphone jack. 2 Volume Control You can rotate the volume control wheel located on the top of the unit clockwise to increase volume, counter-clockwise to decrease volume. 3 Deep Bass Boost The deep bass boost selector switch located on the top back of the unit provides better bass response. Best result will be achieved when using headphones.
5
5 Speaker/Headphone Selector On the top left side of the radio you will find the output selector switch. With this selector switch you can choose to use the built-in speaker, or headphones. To use speaker: Set selector switch to SP. Selection To use Headphones: • In Stereo Mode: Set selector to ST. If the station is tuned in stereo there will be a headphone indicator with ST. on the tip middle part of the display. • In M ono: Set selector to MO.
7
10 My Favorites 11 Lock Switch The lock switch prevents accidental changing of any of the radio settings. • To enable the lock function slide the lock button located on the right side of the unit to the up position. When lock is activated there will be this symbol located on the top of the display. At this time no buttons should function. • To disable the lock function, slide the switch to the down position. 12 Belt Clip A removable belt clip is provided on the back of the unit.
Battery Installation NOTE: A flashing “E” appearing on the LCD display indicates a weak battery and that replacement of batteries is required. • Turn radio off. • Prepare replacement batteries to ensure a quick and easy change. Failure to change batteries within 1 minute will reset presets and clock settings. • The battery cover is located on the back of the unit. Apply a gentle downward pressure and slide the door to the right side of the unit.
Manual Step Tuning • Turn radio on using the On/Off button located on the top of the radio. • Select desired band by pressing the “Band” selector on the front of the unit. • Press the desired tuning button (Up/Down) repeatedly until desired frequency is found. Memory Tuning To tune in stations already programmed into memory. See Setting Memory Section for instructions on how to program stations into radio memory. • Turn radio on using the On/Off button located on the top of the radio.
Setting the Clock This unit features a clock that will display the current time while off. To set the clock: • Turn unit off by depressing the power button located on the top of the radio. • Press and hold MEMO or CLOCK button until the hour setting begins blinking and the colon is no longer blinking. • Select hour by using the Tuning Control Buttons located just to the right of the display. Adjust UP or DOWN accordingly until desired hour is displayed. • Press MEMO or CLOCK button once to set the minutes.
SPECIFICATIONS Band Frequency: AM 520 - 1710 kHz FM 87.5 - 108 MHz TV ch 2 - 13 (VHF) Earphone Jack: 3.5mm mini-plug 16 ohm impedance (stereo) Output Power: 60mW (10% THD) via built-in speaker 16 ohm impedance (stereo) Speaker: 1 inch diameter, 4 ohms impedance External Power: Speaker Earphones AM 60 50mA FM/TV 70 60mA Batteries: 3 Volts (AA size)x2 Dimensions (WxHxD): 2.5” W x 4.2” H x 1.2” D Weight: 3.8 ounces approximately without batteries.
