Control Locations 1. Telescopic Antenna 2. Display (L.C.D) 3. Display illuminated button (LIGHT) 4. Power on/off button 5. Sleep (auto shut off) button 6. Display button 7. Standby button (ALARM) 8. Alarm by radio or buzzer selection 9. Manual/auto scan tuning buttons 10. Enter command button for frequency and time. 11. Numbered buttons for frequency and time. 12. Memory set button 13. Memory scan and dual time. 14. SW meter band also 12/24 Hour select button 15. Radio band selection 16.
Choosing a power supply This radio can be operated using 4 Alkaline UM-3 (LR6) (AA size) batteries Household AC adaptor (not supplied) Installing batteries 1.Position the radio face down. 2.Press the catch marked "OPEN" and side in the direction shown 3.Insert the 4 UM-3 (LR6) (AA size) batteries 4.Replace the battery cover Battery replacement The battery indicator will display the battery condition for approx. 7 seconds after the radio is switched On.
Setting the dual time In addition to real time, a dual time can be programmed into the radio. 1.Press MEMO SCAN (DUAL TIME) button, display will flash “ ” 2.Press ENTER button within 7 seconds, the display “ ” will stop flashing. 3.Press ENTER button again, the “ ”dual time symbol flashes, whilst the “ ” is flashing, set the dual time by pressing the numbered buttons. 4.The rest of the operation is same as setting real time. 5.Press DUAL TIME button again ENTER button to return to real time. Note: a.
Manual tuning 1.Press the POWER on/off button to turn on the radio. 2.Select a waveband by pressing BAND button. 3.A single press on the either the TUNING UP “ ” or DOWN “ ”buttons will change the frequency up or down. Note: Each press of the up or down button will change the frequency in increment of FM 100kHz MW 9kHz/10KHz SW 5kHz Scan tuning 1.Turn on the radio by pressing the POWER on/off button. 2.Select a waveband. 3.
3.Press the numbered button corresponding to the preset memory location for the required station .The radio will instantly tune to the station and the display will show its frequency and memory location. Select Short Wave Meter band 1.Turn on the radio by pressing the POWER on/off button. 2.Press BAND button to select the SW waveband . 3.Press SW SELECT button to select the required SW meter band ,display will appear frequency and SW meter band it belongs to .This radio covers SW 120 to 11 meter band.
ALARM button again to cancel the alarm, The alarm symbol will flash for 7 seconds and disappear. Note: 1.When the alarm is sounding, press POWER button to turn off the alarm for 24 hours. 2.The radio alarm will last for one hour if not turned off by pushing the POWER button. 3.Tune the radio to the required station before setting the alarm. When the alarm operates, the radio will play the last station selected.
removed form the display. Light Pressing the light button located on the top of the radio will turn on the light and illuminate the display for approximately 7 seconds. MW step switch 1.This switch located on the bottom side of the radio provides a means of changing the MW step from 9kHz to 10 kHz. In Europe and most other parts of the world, set the switch to the 9 kHz position. For the USA and Canada, set the switch to the 10kHz position.
Circuit features Semiconductors Aerial system Output Power Sockets Headphones socket DC in Accessories 1 LSI,5IC'S, 2 FET ,39 transistors ,34 diodes,1 LED MW Built in ferrite aerial SW Telescopic aerial FM Telescopic aerial 180 m W 3.
