BLUEBOX BB-100 中文 GB Version 1
GB The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by SANGEAN ELECTRONICS INC. is under license.
Important Safety Instructions 1. 2. 3. 4. 5. 6. 7. 8. Read these instructions. Keep these instructions. Heed all warnings Follow all instructions Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9. Do not defect the safety purpose of the polarized or grounding type plug.
For United States: Cautions to the user The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
4
Controls Volume Control knob Tuning Control knob 3 FM antenna 4 Charge LED indicator 5 Bluetooth status indicator 6 LCD display 7 Preset 1/Rewind button 8 Preset 2/Play/Pause button 9 Preset 3/Fast-forward button 10 Power button 11 Band/Step button 12 Preset 5 13 Preset 4/Bluetooth pairing button 14 Speaker 15 Battery Compartment 16 AC power cord storage 17 AC power cord 18 Rechargeable battery (Charger)/Normal battery (Batteries) Switch 19 Aux In socket 1 2 GB LCD Display A B C D Band Indicator Frequenc
Power the radio 1. Installing the batteries, first turn the battery cover knob anti-clockwise to loosen and open the battery cover. Note: Before you insert the batteries, if you use non-rechargeable batteries, make sure the Charger/Batteries switch which is located inside the battery compartment is switched to the Battery position. If you use rechargeable batteries, make sure to switch Charger/Batteries switch to Charger position. 2. Insert 4 X C size (UM-2) battery into the compartment.
IMPORTANT INFORMATION ON CHARGING AND USING RECHARGEABLE BATTERIES 1. Recharge the batteries in any case at least every 2 months. 2. Make sure the Battery Select switch inside the battery compartment is set to the “CHARGER” position. 3. Put the batteries in the compartment while paying attention to the correct polarity of the batteries (+ and -). 4. First use: Charge new batteries in one continuous, uninterrupted, charge until they are full. This first charge may take longer than normal.
Manual Tuning 1. Press the Power button to turn on the radio. 2. Select the required frequency band by pressing the Band/Step button. 3. Be sure to screw in the rubber FM antenna properly to get best reception. For the AM band, rotate the radio to get best signal as the AM antenna is built into the radio. 4. Rotating the Tuning Control knob will change the frequency in the following increments FM: 50 or 100 kHz AM: 9 or 10 kHz 5. Rotate the Volume Control knob to achieve your required sound level. 6.
Software version/Setting tuning step Software version The software display cannot be altered and is just for your reference. 1. When the radio is switched off, press and hold the Band/Step button for 3 seconds until software version 'PXX' is shown on the display. GB Setting tuning step The Tuning steps in some countries maybe different from where you purchased the radio.
4. Use the controls on your Bluetooth-enabled device or on the radio to play/pause and navigate tracks. Note: 1) If 2 Bluetooth devices are pairing for the first time, both must search for your radio, it will show its availability on both devices. However, if one device links with this unit first, then the other Bluetooth device will not be found on the list. 2) If you take your source device out of range, the connection will be temporarily disconnected to your radio.
Disconnecting your Bluetooth device 1. Press and hold the Bluetooth pairing button for 2 seconds on the radio to disconnect with your Bluetooth device or turn off the Bluetooth function on your Bluetooth device to disable the connection. You will hear a beep and the Bluetooth status indicator on the radio will flash a fast blue to show the radio is discoverable again for pairing. 2. You can also press the Band/Step button to select any mode other than the Bluetooth mode to disable the connection.
Specifications Frequency Coverage FM: 87.50 - 108 MHz AM: 520 - 1710 kHz (10 kHz) 522 - 1710 kHz (9 kHz) AC Power AC 120V/60Hz/10W Batteries: 4 x C Size/UM-2/LR14 (4000mAh Battery is recommended) Output Power 2 Watt 10% T.H.D. @ 100 Hz @ DC battery 6V 4.5 Watt 10% T.H.D. @ 100 Hz @ AC 120V Bluetooth Bluetooth specification Profile Support Bluetooth Audio CODEC Transmitting Power Line of sight range Bluetooth® Ver. 4.1 A2DP, AVRCP1.
