User Manual

Disconnecting your Bluetooth device

1. Press and hold the Bluetooth pairing button for 2 seconds on the radio to disconnect with your Bluetooth

device or turn off the Bluetooth function on your Bluetooth device to disable the connection. You will

hear a beep and the Bluetooth status indicator on the radio will ash a fast blue to show the radio is

discoverable again for pairing.

2. You can also press the Band/Step button to select any mode other than the Bluetooth mode to disable

the connection.

Reset the radio

If your radio fails to operate correctly or some digits on the display are missing or incomplete, please

carry out the following procedure.

1. Make sure your radio is switched off.

2. Press and hold the Preset button 5 and Band/Step button at the same time for more than 2 seconds,

the “dEF” symbol will appear and ash on the display. Continue holding down these two buttons jointly

until all the icons show on the display. All saved preset stations and Bluetooth memory will be cleared

and the radio will revert to the factory default settings.

Aux In socket

The Aux In socket is to connect an audio source (like MP3 player or CD walkman) to listen to the audio

program via the speaker.

Remove the rubber cover, connect the audio source with a 3.5 mm (not included) audio connector wire,

and rotate the Volume Control knob to your preferred listening level.

Note:

You’ll need to plug in a 3.5 mm audio connector in order to change to the Aux in band.