Operation Manual

Manual tune – FM

1. With radio switched on and in FM band, fully extend wire aerial.

2. Press the Tuning Up or Down buttons to tune to a station.

The frequency will change in steps of 50 kHz. Press and hold the

buttons will advance the frequency several times each second. If the

radio is tuned to a station of sufficient signal strength with RDS

information present, then the display may change to show the

station name.

3. When the end of the waveband is reached, the radio will recommence

tuning from the opposite end of the waveband.

4. Set the Volume Control to the desired setting.

5. To switch off your clock radio, press the On/Standby button.

Display will show Standby.

6. The display will revert to a conventional time display mode after

10 seconds of last operation except when displaying scrolling text.

Display modes – FM

Your radio has a range of display options when in FM mode. Note that

the display will revert to a conventional time display mode after

10 seconds of last operation except when displaying scrolling text.

The Radio Data System (RDS) is a system in which inaudible digital

information is transmitted in addition to the normal FM radio program.

In your radio, RDS offers several useful features listed below.

Press the INFO button to cycle through the various modes

a) Time –

Displays the current time.

b) Date –

Displays the current date.

c) Radio text –

Displays scrolling text messages such as artist/track name,

phone in number, etc.

d) Program type –

Displays type of station being listened to e.g. Pop, Classic, News, etc.

e) Frequency –

Displays the frequency of the station being listened to.

f) Audio type –

Display the audio type to be stereo or mono for the station being

listened to.