DPR-69+ GB
Contents Controls ................................................................................. 2-3 Stereo / Mono setting - FM .................................................. 17 Battery operation .................................................................. 4-5 Scan sensitivity setting - FM ................................................ 18 Using the AC adaptor .............................................................. 6 Software version ................................................
Controls GB (Front) 1. Speaker 2. Band button 3. Auto Tune button 4. Info button 5. Volume Down button 6. Volume Up button 7. On / Off button 8. Lock switch 9. Charge / Battery Low indicator 10. Tuning Up / Down buttons 11. Select button 12.
Controls (Back) 13.Battery compartment 14.Telescopic aerial 3 15. Headphone socket 16.
Battery operation using alkaline batteries GB 1. Remove the battery cover on the back of the unit by sliding the cover in the direction of the arrow. 2. Slide the switch inside the battery compartment to the Alkaline position. 3. Insert four LR6 (AA size) alkaline batteries into the spaces in the compartment. Take care to ensure all batteries are inserted with the correct polarity as shown on the back of the radio. Then replace the battery cover.
Battery operation using rechargeable batteries 1. Remove the battery cover on the back of the unit by sliding the cover in the direction of the arrow. 2. Slide the switch inside the battery compartment to the NiMH position. 3. Insert four Rechargeable LR6 (AA size) batteries into the spaces in the compartment. Take care to ensure all batteries are inserted with the correct polarity as shown on the back of the radio. The radio is designed to be used with Nickel Metal Hydride (NiMH) rechargeable batteries. 4.
Using the AC adaptor GB Your radio is supplied with a Mains Adaptor. 1. Place your radio on a flat surface. 2. Insert the adaptor plug into the DC socket located on the left hand side of your radio. 3. Plug the adaptor into a standard 13 amp mains socket outlet. Whenever the adaptor is used with the radio, it will take power from the mains rather than from the batteries. The AC adaptor should be disconnected from the mains supply and the radio when not in use.
Operating your radio - DAB 1. Carefully extend the telescopic aerial. 2. Press the On/Off button to switch on your radio. The display will show “Welcome to Digital Radio” for a few seconds. 3. If this is the first time the radio is used to scan of the Band III DAB channels will be carried out. The display will show “Welcome to DAB”. If the radio has been used before the last used station will be selected. 4.
Selecting a station - DAB GB 1. The top line of the display shows the name of the station currently selected. 2. Press the Tuning Up/Down buttons to scroll through the list of available stations. 3. Press and release the Select button to select the station. The display may show “Now tuning...” while your radio finds the new station. 4. Adjust the Volume up or Down buttons to the required setting. Note: If after selecting a station the display shows “Service not available“.
Display modes - DAB Your radio has seven display modes:1. Press the Info button to cycle through the various modes. a. Scrolling text Displays scrolling text messages such as artist/track name, phone in number etc. b. Program Type Displays the type of station being listened to e.g. Pop, Classic, News etc. c. Multiplex Name Displays the name of DAB multiplex to which the current station belongs. d. Time and date Displays the current the time and date. e.
Finding new stations - DAB GB As time passes new stations may become available. To find new stations proceed as follows:1. With the radio switched on and in DAB mode, press and release the Auto Tune button. The display will show "Scanning..." and your clock radio will perform a scan of the Band III DAB channels. As new radio stations are found the station counter on the right-hand side of the display will increase and the radio stations will be added to the list stored in the radio.
Manual Tuning - DAB Manual tuning allows you to tune directly to the various DAB Band III channels. Note that DAB stations are located in the range of 5A-13F. 1. Press and hold the Select button until the display shows “Manual tune”. Release the Select button. 2. Press either of the Tuning Up/Down buttons to select the required DAB channel. 3. Press and release the Select button to select the required DAB channel.
Dynamic Range Control settings - DAB GB Dynamic Range Control (also known as DRC) can make quieter sounds easier to hear when your radio is used in a noisy environment. 1. Press the On/Off button to switch on your radio. 2. Press and hold in the Info button. The display will show “Station list.” 3. Press the Tuning Up/Down buttons until the display shows “DRC value”. 4. Press and release the Select button to enter adjustment mode. 5.
Operating your radio - FM 1. Carefully extend the telescopic aerial. 2. Press the On/Off button to switch on your radio. The display will show “Welcome to Digital Radio” for a few seconds. 3. Press the Band button to select the FM band. 4. Press and release the Select button until the display shows “Auto tune <>”. 5. Press the Tuning Up button. Your radio will scan from the currently displayed frequency direction upwards and will stop scanning when it finds a station of sufficient strength. 6.
Manual tuning - FM GB 1. Press the On/Off button to switch on your radio. 2. Press the Band button to select the FM band. Fully extend the Telescopic aerial. 3. Press and release the Select button until the display shows “Manual tune < >”. 4. Press either the Tuning Up or Down buttons to tune to a station. The frequency will change in steps of 50kHz. Pressing and holding one of the buttons will advance the frequency selection several times each second. 5.
Display modes - FM In FM mode the bottom line of the display can be set any of four display options. 1. Press the Info button to cycle through the various options. a. Radio text Displays scrolling text messages such as artist/track name, phone in number etc. b. Program Type Displays the programme information for the station being listened to e.g. Pop, Classic, News, etc. c. Time and date Displays the current time and date. d. Frequency Displays the frequency of the station being listened to.
Presetting stations - DAB and FM GB There are 5 memory presets for each of the two wavebands. 1. Press the On/Off button to switch on your radio. 2. Tune to the required station as previously described. 3. Press and hold the required Preset button until the display shows, for example, “Preset 1 stored”. The station will be stored under the chosen preset button. Repeat this procedure for the remaining presets. 4. Stations stored in the presets may be overwritten by following the above procedure.
Stereo / Mono setting - FM Your radio will play stereo broadcasts in stereo (via headphones) so long as the received signal is of adequate strength. However, as a stereo signal becomes weaker the audio signal will become poorer. It may be preferable to force the radio to play the station in mono in order to reduce the level of audio noise. 1. Press the On/Off button to switch on your radio. 2. Tune to the required FM radio station as previously described. 3.
Scan sensitivity setting - FM GB Your radio will normally scan for FM broadcasts which are strong enough to give good reception. However, you may wish the Auto-scan function to also be able to find weaker signals, possibly from more distant radio transmitters. Your radio includes a local / distant option for the Auto-scan function. 1. Press the On/Off button to switch on your radio. 2. If needed, press the Band button to select the FM band. 3.
Software version The software display cannot be altered and is just for your reference. Ensure your radio is switched on and in DAB mode. 1. To view the software version on the display press and hold the Info button for 2 seconds. 2. Repeatedly press the Tuning Up/Down button until the display shows “SW version“ on the lower line. Press the Select button to enter the SW version. The version number is then shown on the lower line of the display. Press and release the Info button to normal tuning mode.
Headphone socket GB A 3.5mm Headphone Socket located on the left hand side of your radio is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker. IMPORTANT: Excessive sound pressure from earphones and headphones can cause hearing loss. Display backlight 1. When using on batteries, the display backlight will be switched on for approximately 12 seconds when any button is pressed. 2.
A Few Words about Batteries... Your radio has been designed to use a choice of power sources. You may plug it into the mains using the supplied high-efficiency adaptor, or for listening away from the mains you may use either alkaline or rechargeable batteries. We do not recommend the use of carbon-zinc or zinc-chloride batteries. It is very important that you read the advice and warnings given below.
If you use the radio powered from the batteries, the battery light will be off until the batteries are exhausted. The battery light will then show red for a short while before the radio switches itself off. It does this in order that the batteries are not excessively discharged. This would otherwise damage the batteries and shorten their life. If you use the radio powered from the mains with rechargeable batteries fitted, the charging process is suspended until you switch off the radio.
General Do not allow this radio to be exposed to water, steam or sand. Do not leave your radio where excessive heat could cause damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high. It is recommended that the DAB band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the FM band. The name plate is located on the back of your radio.
GB If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
