DT120/DT-180V instruction manual FM-stereo/AM/TV ( DT-180V ) Digital Personal Receiver Controls 1. LCD display 2. Band selection 3. DBB ( Deep Bass Booster ) On / Off 4. Tuning Control 5. Stereo/Mono switch 6. Power On/Off 7. Volume Control 8. Lock Switch 9. Battery Compartment 10. Memory button 11.
Display A. Selected Band B. 90 minutes auto shut off C. System lock D. FM stereo indicator E. Battery power indicator F. Memory presets G. DBB on H. Frequency Battery Installation Battery cover is located on the back of the unit . Slide the cover in the direction of the arrow to gain access to the battery compartment . Insert one AAA (UM-4) battery into the compartment . Make sure that the battery is positioned in accordance with the indicated diagram . Replace cover . Note : 1.
earphone to the receiver acts as an antenna during FM and TV (DT-180V) audio reception and should be extended as much as possible to increase the sensitivity . A built-in ferrite bar antenna is provided for AM reception and it is only necessary to rotate the radio for maximum signal strength during AM listening . Important Note : The radio will be auto shut off within 10 seconds when you unplug the earphone from earphone jack for battery power saving .
Turn on the radio , select required band by pressing Band Selection button . Press and hold down the Tuning Control buttons for more than half a second and release the button to commence Scan Tuning . The radio will scan and stop automatically when a station is found . Manual tuning Turn on the radio, select required band by pressing Band Selection button . Desired station may be selected by pressing the Tuning Control buttons intermittently until the desired station is reached .
1. Change the AM band tuning step from 9 kHz to 10 kHz When radio is OFF , press and hold Tuning UP button then switch on radio by pressing Power On/Off button until LCD display flashes 10 and then 520 , indicating AM step has been changed to 10 kHz tuning step . 2.