Instruction manual

Turn on the radio , select required band by pressing Band Selection
button . Press and hold down the Tuning Control buttons for more than
half a second and release the button to commence Scan Tuning . The
radio will sc an and stop automatically when a station is found .
Manual tuning
Turn on the radio, select required band by pressing Band Selection
button . Desired station may be selected by pressing the Tuning Control
buttons intermittently until the desired station is reached . Or pressing and
holding the Tuning Control until the desired station is reached .
Memory Tuning ( Station Preset )
Turn on the radio by pressing Power On/Off button . Select required band
by pressing Band Selection button . Tune to the desire d station using the
Scan or Manual tuning described above . When the desired station is
reached , press and hold Memory button for more than 2 seconds until
display M x stop flashing followed with a beep ( via earphone ) . It will
replace previous memory s tation .
You may store 5 memory stations each band ( AM , FMI , FMII and
TV ) .
Recall memory stations
Turn on the radio , select required band then simply press and release
Memory station button . LCD display will show Memory preset and radio
frequency .
Stereo/Mono switch
The radio is designed to receive FM stereo broadcastings . For weak FM
station , switch Stereo/Mono to Mono position . LCD display Stereo icon
will disappear .
Change AM band tuning step
For Northern American countries and some South American countries ,
AM tuning step is 10 kHz . On other countries is 9 kHz .
To change AM band tuning step , please follow below steps .