LOCATION OF CONTROLS Congratulations and welcome to The SANGEAN WORLD OF LISTENING! To insure proper operation please famililarize Yourself with these instructions before using your New receiver 1 . On/Off Button 2 . Vo l u m e C o n t r o l 3 . Earphone Jack 4 . Lcd Ddisplay 5 . Tuning Control 6 . Tuning Control 7. Band Selection Button 8. Mono/Stereo Button 9. Memory Button 10. Select Button 11. Speaker On/Off Switch 12. Battery Compartment 13. Lock Switch 14.
4 11 9 10 2 1 5 6 7 8 13 3
14 12 4
BATTERY INSTALLATION The battery cover is located on the back of the unit. Slide the cover in the direction of the arrow to gain access to the battery compartment(12). Insert 2 AA batteries into the compartment(12). Make sure that the batteries are positioned in accordance with the diagram located below batteries in battery compartment. Replace cover.
ANTENNA/EARPHONE USE The cord connecting the headphones to the receiver acts as an antenna during FM/TV reception and should be extended as much as possible to increase FM/TV sensitivity . Insert the Earphones into the Earphone Jack(3).Abuilt-in Ferrite Antenna is provided for AM reception and it is only necessary to rotate the radio for maximum signal strength during AM listening SPEAKER ON/OFF SELECTOR speaker Output may be turned on or off using the Speaker ON/OFF Selector (11).
TUNING THE RADIO BAND FREQUENCY ANTENNA AM 520-1710KHZ Internal/Rotate radio for best reception FM 87.5-108MHZ External/Make sure Headphones are inserted into Headphone Jack TV ch.2-13(VHF) External/Make sure Headphones are inserted into Headphone Jack A SCAN TUNNING Turn on the Radion by pressing On/Off Button (1).Select AM,FM or TV Band by pressing Band Selection Button(7) and then press and Hold the Tuning Control(5) or(6) for more than 1/2 second.
B MANUAL TUNING Turn on the Radio by pressing On/Off Button (1). Select AM,FM or TV Band by pressing Band Selection Button (7).Desired station May be selected by either pressing the Tuning Control(5)or(6) intermittently until the desired Station is reached or pressing and holding the Tuning Control until the desired station is Reached. Release and push the Tuning Control once again to retain the desired Station. C MEMORY TUNING(STAION PRESET) Turn on the Ridio by pressing On/Off Button (1).
In the LCD Display. You may store a total of 19 stations in any mix from any band.Original stations are eliminated when new stations are selected to take their places. D MEMORY TUNING (STATION RECALL) Turn on the Radio by pressing On/Off Button (1). Select AM, FM or TV Band by pressing Band Selection Button (7). Pressing and Holding the Select Button (10) for more than 1/2 second will begin displaying the stored station and their associated numbers one by one in the LCD Display .
LOCK SWITCH To prevent accidental changing of any o the radio settings move the Lock Switch (13)to its up , locked position( ). To release simply move the switch to its down position. IT IS IMPORTANT TO MAKE SURE LOCK SWITCH IS IN ITS DOWN POSITION WHEN RADIO IS TO BE USED AS RADIO IS COMPLETELY INOPERATIVE UNTIL LOCK SWITCH IS RELEASED . If the Radio is not to be Used for any extended period of time battery power Savings may be realized by setting-Lock Switch In its locked ( ) position during storage.
SPECIFICATIONS Type: FM-Stereo(Via headphones) AM Standard(mono) TV Band (mono, CH. 2-13VHF) Earphone Jack:3.5mm mini-plug 32 ohm impedance (stereo) Output Power:60mW(10%THD) Via built-in speaker 32 ohm impedance(stereo) Speaker:1 inch diameter, 4 ohms impedance External Power: Speaker AM 60 FM/TV 78 Earphones 50MA 68MA Batteries:3 Volts(AA size)x 2 Dimensions (Wx Hx D): 4 3-8"Hx2 5/8"W x3/4"D Weight:5.0 ounces approximately without batteries.
MAINTENANCE 1.Keep the radio dry. If it does get wet, wipe it immediately. Liquids may contain chemicals that can corrode electronic circuitry. 2.Use and store your radio only in normal temperature environments. High temperature can shorten the life of electronic devices, damage batteries and melt plastic parts. 3.Handle the radio gently and carefully. Dropping it can damage circuit boards and cases and render it defective. 4.Keep the radio away from dust and dirt. 5.