Full Product Manual

GBGB

If the clock time was not auto adjusted within 24 hours, the symbol “CT” will disappear on the display.

If the clock time from local RDS / RBDS station is not correct, you should consider disabling the

“RBDS Auto CT” function and set the time using the manual setting.

Please note that at times the RDS / RBDS signal may broadcast the wrong time, this is the fault

of the radio station and not your radio.

Using the AC power adaptor

Auto clock set mode

The AC power adaptor required for this unit should be 6 volts DC at 2A center pin positive. Insert

the adaptor plug into the DC socket on the rear of the radio. Plug the adaptor into a standard AC

outlet. If no time is displayed, the screen will show ----:----. The AC adaptor should be disconnected

from the AC outlet when not in use for long periods of time.

Fully extend the wire antenna located on the rear of your radio.

Press and release the Power button to switch on your radio. It may be necessary to relocate your

radio to get better reception.

Press the Power button to switch on your radio.

Press the Band button to select FM radio mode.

Press and hold the Menu button to enter the menu setting and then press the Tuning up / down

button to select “RBDS Auto CT”. Press the Select button to enter the setting.

Press the Tuning up / down button to select “Auto” or “Manual”. With “Auto” selected, press the

Select button to conrm the setting. Your radio will synchronize its clock time whenever it tunes

to a radio station using RDS / RBDS with CT signals. The symbol “CT” will appear on the display

indicating the radio time is RDS / RBDS clock time.

If you wish to cancel the “RBDS Auto CT” function, select “Manual” and press the Select button to

conrm the setting. Please refer to the next section “Setting the clock manually” to set the clock

time and date.

The display will revert to a conventional time display 10 seconds after

the last button press except when displaying scrolling text.

NOTE

The AC adaptor is used as the means of connecting the radio to the power supply. The AC Adapter

used for the radio must remain accessible during normal use in order to disconnect the radio from the

power supply completely, the AC Adaptor should be removed from the power supply outlet completely.

IMPORTANT