LUNCHBOX GB Version 1
IImportant Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings 4. Follow all instructions 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus ( including amplifiers ) that produce heat. 9.
10. Protect the power cord from being walked on or pinched particularly at plug, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13.
3
Controls 1 2 3 4 5 6 7 8 9 10 Volume Control Tuning Control FM antenna LCD display Power On/Off Band Selection Preset Station Speaker Battery Compartment AC power cord storage LCD Display A B C D Band Indicator Frequency Preset Stations Low Battery Indicator GB 4
Power the radio 1. Battery operation Installing the batteries, first turn battery cover fixture anti-clockwise to loosen and pull down the battery cover. Insert 4 x C size (UM-2) battery into the compartment. Ensure the battery is inserted in accordance with the diagram shown. Close the battery cover and fasten the fixture by turning clockwise. If the radio is not to be used for any extended period of time, it is recommended that the battery is removed from the radio.
2. AC operation Before you plug the AC power cord into the AC socket, be sure the voltage is correct. If you have batteries in the radio and use the AC power cord, the batteries will automatically be disconnected. AC power storage is designed to store the cord when the radio is not in use. 3. Operating the radio This radio is equipped with two tuning methods – Manual tuning and Memory presets recall. Manual Tuning 1. Press the Power button to turn on the radio. 2.
Memory presets recall Storing stations in preset memories There are 5 memory presets for each waveband. 1. Press the Power button to turn on the radio. 2. Tune to the required station using Tuning Control. 3. Press and hold down the required preset until the radio beeps. The preset number will appear in the display and the station will be stored under chosen preset button. 4. Repeat this procedure for the remaining presets. 5.
Setting tuning step Tuning steps on some countries are different from where you purchase the radio. If you buy the radio in Europe and intend to use in Northern America or some Latin American countries, you may have to adjust tuning step so the radio may continue to serve you well. While radio is switched off, long press the Band button for approx. 7 seconds until display flashes current FM tuning step 50 ( kHz ). Rotate the Tuning Control, you may adjust to 100 ( kHz ).
Specifications Frequency Coverage: FM 87.50 – 108 MHz AM ( MW ) 520 – 1710 kHz ( 10 kHz ) 522 – 1629 kHz ( 9 kHz ) AC Power: AC 120V/60Hz/10W (USA ) AC 230V/50Hz/10W (Europe ) Batteries: 4 x UM-2 ( C Size ) Output Power: 2 Watt 10% T.H.D. @ 100 Hz @ DC battery 6V 5 Watt 10% T.H.D.
