MMR-88 中文 GB Version 1
Important safety instructions 1. Please read these instructions carefully. 2. Please keep these instructions for future reference. 3. Heed all warnings 4. Follow all instructions 5. Do not use this apparatus near water 6. Clean only with dry cloth 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9.
13. Unplug this apparatus during lightning storms or when unused for a long period of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture does not operate normally or has been dropped. 15.
Controls LED Flashlight switch Solar charging panel 3 Charging indicator 4 Tuning LED indicator 5 LCD display 6 Tuning Up 7 Power button 8 Tuning Down 9 Speaker 10 Emergency siren button 11 Display/Mono button 12 Band selection/Time set button 13 Preset station 14 Volume Control -down 15 Volume Control - up 16 LED Flashlight 17 3.
LCD display icon A B C D E F G H Battery power level meter FM stereo indicator Auto shut off indicator Memory preset Time and radio frequency AM/PM local time indicator AM Frequency Band FM Frequency Band A B C D H G F E The MMR-88 is powered by an 850mAh rechargeable Lithium-ion battery (supplied). Before operating the radio for the first time, ensure that you fully charge the supplied battery.
Inserting the supplied rechargeable battery 1. Open the battery compartment on the back of the unit by pushing the battery door following the arrow direction. 2. Insert the supplied rechargeable battery into the space in the compartment. Make sure the battery is inserted with correct polarity as shown in the compartment. Recharging the radio Note: Please use one of the following methods to recharge your radio or when the battery power indicator LED blinks indicating the battery power is low. 1.
Using Dynamo power 1. Make sure the telescopic antenna is in the rest position before rotating the dynamo handle. 2. Take the Dynamo power handle from its rest position. 3. Rotate the Dynamo power handle approx. 120 rotations per minute, either clock-wise or counter-clock wise until the charging LED indicator appears red. 4. Under normal listening conditions, one minute of charging from Dynamo power will allow you to listen to the radio for approx.
Note: The best performance of the solar panel will be achieved when the sun is directly overhead, and the sunlight is unobstructed by clouds, foliage, GB curtains etc. In certain situations and poor light conditions, the solar panel may not be effective and should not be relied upon as the primary energy source for standard usage. The solar panel is designed as a supplementary energy source which under suitable light conditions is able to contribute up to 100% of the radio energy requirements.
Tuning the radio - using Seek Tuning, Manual Tuning and Memory preset recall. Seek Tuning Turn the radio on by pressing the Power button. Select the desired band by pressing the BAND button. Press and hold the Tuning UP/Down button for approx. 1/2 second, the radio will seek for the next active station. Repeat as many times until the desired station is found. Manual tuning Turn the radio on by pressing the Power button; select the desired band by pressing the Band button.
Recall stations 1. Turn on the radio, press the PRESET button to enter the preset mode, GB the display will show your last preset station position. 2. Press the Tuning Up/Down button to select your desired preset station. 3. Press and release the PRESET button to skip preset mode, the P (preset) and preset position will disappear. You may then press the Tuning UP/Down button to tune to the next desired station. Telescopic Antenna The telescopic antenna is used for the FM reception.
Changing the AM/FM tuning step In Europe and other parts of the world the AM tuning step is 9 kHz, in North America the AM tuning step is 10 kHz. FM tuning steps also vary from country to country. To change the AM/FM tuning step, proceed as follows. 1. When the radio is turned OFF, press and hold the PRESET button for approx. 2 seconds, the display will first show software version (e.g. P01) then blink the FM tuning step 100 (kHz).
Listening with Headphones Plug the headphones into the headphone socket for private listening. This will disconnect the external speaker. Charging mobile phones and MP3 players The MMR-88 features a USB charging socket to charge your mobile phone or MP3 player and related devices with the its built-in Lithium-ion battery. 1. In order not to interfere with radio listening, we suggest to charge your mobile phone, MP3 player and related devices when the radio is switched off. 2.
Specifications Power Supply: 850mAH rechargeable Lithium-ion battery (supplied) x 1 Dynamo - charging to rechargeable Lithium battery. Solar panel - charging to rechargeable Lithium battery Optional Power Supply: AC power adaptor with Micro USB connector, (not included) Audio Output: 400 mW (DC In (5V/0.5A) Micro USB B Type Socket for Charging the MMR-88. USB A to Micro B Cable & Hand strap included) Frequency Coverage FM (VHF): 87.
