10 3 POWER OFF ON 8 SW1 2 3 4 5 6 7 8 9 10 MW FM 1 2 200mA DC IN 4 5V 4 9 10 5 FM/MW/SW1-10 Sw1 2 3 TUNNG 12 BAND PORTABLE RECEIVER 4 5 6 7 9 10 MW FM 2175 1700 108 2170 1600 106 1200 102 1000 100 900 96 700 94 600 90 2165 2160 6 2155 2150 2145 530 60m 49m 41m 31m 25m 21m 19m 16m 15m 13m Khz 88 7 Mhz METER BAND FREQ (Mhz) 11 2
Location of Controls 1. Power knob 2. Band and SW band selector 3. Tuning knob 4. Volume Control 5. Tuning LED 6. Tuning pointer 7.
Power Supply The Battery Compartment 11 is located at the back of the unit. Open it by sliding the cover in direction of the OPEN. Insert 3 AA (UM-3) size batteries in compartment, then replace the cover. Alternative Power Supply This unit is fitted with a 4.5V DC power socket 9 which will accept a 4.5V 150 mA DC external main adaptor with central negative pin (Adaptor not included). When in use, the adaptor will automatically cuts out the batteries.
Antenna The receiver is fitted with a built-in bar antenna for the MW wavebands reception. This antenna is directional and may be necessary to rotate the set slightly for best reception. FM reception is best obtained by raising the telescopic antenna 10 , then angling it and rotate the set for best reception. SW reception is best obtained by raising the telescopic antenna to its Fullest extent and using the radio with the antenna upright.
Earphones use An earphones jack 8 at the left side of receiver furnishes users to use earphones in reception, the speaker will be disconnected automatically while inserting the earphones. Volume Control Adjust volume control knob 4 by rotating it clockwise for comfortable sound volume.
Tuning methods Turn the radio by switching power knob 1 to on position. Select FM, MW and SW at the band selector 2 . Should you select SW band, then choose the desired SW meter band (SW1-10) by same selector. Then use the tuning knob 3 , tune to the desired station. When a radio stations is tuned correctly, the tuning LED 5 will be lighted on. Turn off the radio by switching power knob to its off position.
Specifications Power Supply : 3 AA (UM-3) batteries. AC/DC adaptor 4.5 V 150 mA center negative.
SW 1 SW 2 SW 3 SW 4 SW 5 SW 6 SW 7 SW 8 SW 9 SW 10 60 meter 49 meter 41 meter 31 meter 25 meter 21 meter 19 meter 16 meter 15 meter 13 meter 4,75 5,90 7,10 9,40 11,60 13,57 15,10 17,48 18,90 21,45 - 5,06 6,20 7,35 9,90 12,10 13,87 15,80 17,90 19,02 21,85 MHz MHz MHz MHz MHz MHz MHz MHz MHz Mhz 9
Semi-Conductors : 11C, 1 FET 1 diode . Speaker : 2.5 inch, 8 ohm 0.5 Watt Output Power : 150 mW 8 ohm (10% THD) for built-in speaker 10 mW per channel for earphones 3.