Operation Manual

53
FM Radio
Operating your radio in FM mode
1. Carefully extend the telescopic aerial and press the Standby button to switch on your radio.
2. Press the Mode button and rotate the Tuning Control Rotary as needed to highlight FM radio
mode. Press the Tuning Control Rotary to select the option.
3. Rotate the Tuning Control Rotary in a clockwise direction. The displayed frequency will increase.
Press the Tuning Control Rotary to carry out an auto-tune. Your radio will scan up the FM band
from the currently displayed frequency and will stop scanning when it nds a station of sufcient
strength.
4. The display will show the frequency of the signal which has been found. If RDS information is
available, after a few seconds the display will show the radio station name. If you only hear hiss
or interference, simply press the Tuning Control Rotary to scan further. Your radio may have
found a spurious interference signal.
5. To nd more FM stations press the Tuning Control Rotary to repeat the scan operation. To scan
down in frequency, rotate the Tuning Control Rotary in a anti-clockwise direction rst and then
press the Tuning Control Rotary. Your radio will scan down the FM band from the currently
displayed frequency and will stop scanning when it nds a signal of sufcient strength.
6. When the end of the waveband is reached your radio will recommence tuning from the opposite
end of the waveband. Use the Volume buttons to adjust the sound level as needed.
1
2
6
3-5
FM
radio
104.90MHz
FM 10:38
FM Radio
V.H.B.N.
FM 10:39
FM Radio