Quick Start Guide

Quick Setup Guide

Connect the Sangean Internet Radio (WFT-1) either to wired or wireless LAN as shown below. This is the same

way as your PC is connected to internet.

* No PC is needed. PC needs to be turned on and connected to the router only when you would like to play music

loaded in your PC (Shared Folder or UPnP).

1. Turn on the router and the internet radio.

2. Connect the devices as the figure above.

3. Turn on the radio by pressing Power knob.

4. Rotate and press the TUNING knob on the radio to

go to “ System Setup -> Internet Setup -> Wizard”

and the unit will automatically connected to

Internet.

5. If there is password for the access point, input and

enter the password using the Tuning knob. Then

radio will connect to the internet. Please read the

instruction manual for all the functions.

* If the wired connection is not working, after a few

seconds the display will change to show ‘Scan for

networks’

1. Turn on the router and power plug the internet radio.

2. Connect the devices as the figure above.

3. Press the POWER button to turn on the unit.

4. Rotate and press the TUNING knob on the unit to go

to “System Setup -> Internet Setup -> Wizard”. The

display will show all the internet connections.

5. Use the TUNING knob to select your access

point/router. It can be your router model name or a set

up name.

6. If there is password for the access point, input and

enter the password using the TUNING knob. Then

radio will connect to the internet. Please read the

instruction manual for all the functions.

* After setting up as above, the unit is connected to internet and ready to be operated. Rotate and press the turning

knob on the internet radio to operate the functions.

PROBLEMS:

CALL TOLL FREE 1-888-SANGEAN (726-4326)

PAGE 1
Quick Setup Guide Connect the Sangean Internet Radio (WFT-1) either to wired or wireless LAN as shown below. This is the same way as your PC is connected to internet. * No PC is needed. PC needs to be turned on and connected to the router only when you would like to play music loaded in your PC (Shared Folder or UPnP). 1. 2. 3. 4. Turn on the router and the internet radio. Connect the devices as the figure above. Turn on the radio by pressing Power knob.
PAGE 2
Troubleshooting If you have difficulty connecting the unit to your network, some of these steps may help to resolve the problem: Problem Cause Suggestion The display shows Network is not connected Check if the router/modem is powered on, and check if the wireless access “Network Error” or it point you connected is correct.. For wired connection, check if the Ethernet spends too much time for is plug in to the internet radio.