Data Sheet

Bluetooth Module 5.0 SBM-2715-C2
www.sangshinec.com Preliminary Specification. Page 17 / 21
11.4. Antenna Assembling
Antenna used for the module should meet the mobile device requirements: The
VSWR is less than 2.0 and the input impedance is 50 ohms Antenna should be
well matched to achieve best performance in different application scenarios.
Antenna interface can be connected to SMA-RP male antenna, embedded planar
inverted F antenna(PIFA). RF wires far away from all disturbing source, especially
digital signals and DC/DC power if using RF wires.
The following methods are commonly used to assemble antenna;
-SMA-RP female connector
The following figure shows its encapsulation specifications.