Operation Manual

DISMANTLING
16
WORK THAT MAY BE REQUIRED
15
ELECTRICAL INSTALLATION MUST BE CARRIED
OUT BY A PROFESSIONAL ELECTRICIAN
Before carrying out any other types of work, disconnect
the Sanicubic from the power supply.
UK
INSTRUCTIONS ONLY FOR QUALIFIED
PROFESSIONAL SPECIALISTS
UNIT ALARM
REMOVING A MOTOR
INSTRUCTIONS RESERVED EXCLUSIVELY
FOR QUALIFIED PROFESSIONAL SPECIALISTS
Unclip the cover.
Unscrew the collar on the
motor (the check valve
stays in place while the motor
is being repaired).
A
Unscrew the collar .
Remove the motor power
wires from the screw
connector.
C
B
Remove the screws from
the inspection cover.
Use the handle to lift the
motor carefully.
E
D
If the faulty motor has to be
sent back to the manufacturer.
PUTTING THE MOTOR
BACK IN PLACE
Re- assembly is the reverse
of the above.
Reconnect the motor power
wires (cf. illustration ).
Warning:
Comply carefully with the
colour code:
Blue wire with the blue wire
Brown wire with the brown
wire
Green wire with the green
wire
White wire with the white
wire
Connect the unit to the
power supply.
Carry out a complete test
for commissioning (cf.
paragraph ).
11
2
16
The unit beeps to show that it
is no longer under power.
PROBABLE CAUSES
Faulty electronic card
1 – Obstructed Dip tube
2 – Pump discharge height too
high
The non-return valve is
leaking or broken
SOLUTIONS
Contact SFA after-sales
service
1 – Remove obstruction from
the discharge pipe
2 – Check installation (**)
Clean or change the valves
Possible secondary maintenance operations
PROBLEM
No motor starts and the mains
GREEN LED is off (*)
The LED war
The LED flashing warning light
ning light is on
PROBABLE CAUSES
No power
1 – Obstructed pump
2 –
Faulty detection system
Blocked Pump
SOLUTIONS
Check your electrical
connections
Press the override button
continuously to get the
pump working
Contact SFA after-sales service
Possible preliminary maintenance operations on the unit
PROBLEM
The motor does not start
but override works + The LED
warning light on
Pump running continuously
Pump starting up
intermittently
(**) Warning: if pumping height is high, 90° elbows should be avoided.
F
4
16
1
16
2
16
3
16
DISCONNECT THE UNIT FROM THE
POWER SUPPLY (the green indicator
light must be off).
N°156 PRO
Alarm reset
The manual override (MO) button switches
off the red LED if the problem is solved
REMOTE ALARM MODULE
FAULT WARNING LIGHT TABLE
Fault
detected
RED LED ON
+ YELLOW
LED OFF
+ BUZZER
RED LED OFF
+ FLASHING
YELLOW LED
+ INTERMITTENT
BUZZER
Probable
causes
1- Blocked
pumps
2- Blocked pumps
3- Problems with
the electric
motors
4- Too much
water flowing in
5- Faulty circuit
board
Mains supply fault
on the appliance
Remedial
action
1- Contact SFA
after-sales
service
Check the
electrical install
(*) override
A
B
C
D
E