Specification

CONNECTIONS
SANICOM I • PART N
O
018
Example of installation. Follow local plumbing codes for actual install.
The Sanicom 1 drain pump is used to pump gray water away from a variety of fixtures in commercial
applications. The system is able to discharge the waste up to 25 feet vertical and/or 250 feet
horizontal. This model was designed to sustain the toughest applications from commercial applications
where hot water can be an issue as it is capable of handling up to 194°F as well as grease..
Discharges the waste through a 1” rigid pipe. The system includes a rubber discharge elbow that
adapts to the discharge pipe as well as a non-return valve. This elbow can be rotated 360 degrees
depending on the discharge installation.
Has been designed with a 1–1⁄4” vent connection on top of the system. All plumbing codes require
connection to a vent system. If codes require the use of a larger diameter vent pipe, this may be
increased by means of an adapter. Please note that the vent system should be a two-way air vent as
air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar
devices is not permitted.
Discharges gray water from commercial kitchens, dishwashers, washing machines, etc. The gray
water will drain into the system via two 2” inlets which are on either side of the housing. Note that
when draining wastewater into the pump through either of the side inlets, an external check valve (not
supplied) has to be installed.
APPLICATIONS
COMMERCIAL
ASME A112.3.4
SANICOM1 Drain Pump
SINK
WASHING
MACHINE
BATHTUB
DISHWASHER
LAUNDRY
SINK
SHOWER
PUMPING DISTANCE
250 Ft
25 Ft
1 1/4’’ Vent
1’’ Discharge
ø
1 1/2’’
Drain
ø
2’’
Drain
Powerful 1 HP
drain pump
meant for
commercial
applications where
hot water can be an
issue as it is capable
of handling up to
194°F.
System is capable
of handling
multiple fixtures
simultaneously.
Powerful motor for
absolute reliability
and efficiency.
AN EASY SOLUTION FOR COMMERCIAL
APPLICATIONS REQUIRING GRAY WATER REMOVAL
32