Specification

CONNECTIONS
SANICONDENS BEST FLAT • PART N
O
044
SANICONDENS BEST FLAT
Example of installation. Follow local plumbing codes for actual install.
The Sanicondens Best Flat is a low profile pump used to neutralize and pump condensate from
condensing boilers, HVAC systems, water heater systems, etc. The Sanicondens Best Flat will pump
condensate waste up to 15 feet in height and/or 150 feet away from a soil stack.
Discharges the condensate waste through a 3 ⁄ 8” vinyl tube. A non-return valve is included on the
discharge connection provided with the system.
Comes with provisions for a ready-to-wire connection to an external overflow switch that will shut
down the appliance or alert the consumer in the event of overflow. It also includes all necessary
hardware for ease of installation; 20 Ft of vinyl tubing, inlet adapter, discharge adapter.
Discharges condensate from a condensing boiler or other condensate producing fixtures.
The condensate will drain into the system via a side inlet or through a couple of inlets on top of the
enclosure.
Comes equipped with a built-in neutralizer to raise pH levels for harsh HVAC applications. Neutralizing
granules come included with the condensate pump. Will neutralize condensate from appliances up to
500,000 BTU/hour input.
PUMPING DISTANCE
15 Ft
150 Ft
ø 3/8” Drain
Drain
Drain
15 ft vertical
2 IN 1 CONDENSATE
PUMP WITH BUILT-IN
NEUTRALIZER FOR
HARSH HVAC
APPLICATIONS
Neutralizing agent (Part# 042)
is used to raise the pH level from
condensate being produced
by condensing boilers, air
conditioners, etc. The two quart
capacity condensate pump
comes equipped with all the
necessary hardware for easy
installation. It can be installed
on top of flat surface or mounted
on a wall.
Ø 3/8’’ barbed x 3/4’’
male connector
AIR
CONDITIONER
BOILER
APPLICATIONS
RESIDENTIAL
HVAC
COMMERCIAL
48