Dimensions Guide

EXTERNAL UNITS - SPECIFICATION SHEET
Discharges the waste through a
3
⁄4" or 1" rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the
system. This elbow can be rotated 360 degrees depending on the discharge installation.
Has been designed with a 1
1
⁄2" vent connection on the top of the lid. All plumbing codes require connection to a vent system. Please note
that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance
valves or similar devices is not permitted.
Must be connected to Saniflo’s 1.28 GPF rear discharge toilet. These toilets come in round and elongated
(ADA compliant) models. More technical information on page 5.
Will also discharge gray water from any sink, bath/shower or urinal. The wastewater will drain into the
system via two 2" inlets with built-in check valves on either side of the housing. Note that when adding
a bathtub/shower, the base should be raised up by a minimum of 6" off the floor.
Designed with two easy access service panels located on top of the pump. On one side
of the pump you can easily access the electrical components and the level sensor.
The other side allows access to the macerating blade for easy removal of foreign objects.
These toilets come in round and elongated
The wastewater will drain into the
on either side of the housing. Note that when adding
TECHNICAL SPECIFICATIONS
The Saniaccess3 is a 1/2 HP pump system used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away
from a soil stack. It incorporates a macerating system which can handle human waste and toilet paper in residential applications.
The blade is made out of a hardened stainless steel material which eliminates the need for any service or replacement.
3
INSTALLATION BEHIND THE TOILET
INSTALLATION BEHIND THE WALL
Pump type: Macerator
Electrical: 120 V – 60 Hz / 4.5 Amps (Max)
Motor: 0.5 HP oil-filled thermally protected motor
Capacitor rating: 45 microfarad
Operating Temperature: 104 F° (110 F° Max.)
Power cord length: 51 inches
Noise level: ≤ 53 dBA (Lp) (measured at 3 ft.)
SANIACCESS3 • Part No. 082
Macerator
© SFA Sanifl o Inc. © SFA Sanifl o Inc.