Specification

CONNECTIONS
SANICUBIC 2VX • PART N
O
099
Example of installation. Follow local plumbing codes for actual install.
The Sanicubic 2 VX is a 1.5 HP heavy duty duplex vortex system used to pump away waste water from
several bathrooms and fixtures from an entire building structure. This system is able to discharge the
waste up to 36 feet vertical and/or 328 feet horizontal using 2” pipe or up to 20 feet vertical and/
or 1640 feet horizontal using a 4” pipe. This lift station is ideal for uncontrolled environments in both
residential and commercial applications (ie. rental unit, offices, warehouses, etc). The Sanicubic 2VX
incorporates a couple of vortex impellers capable of handling up to 2” solids.
Discharges the waste through either a 2” or 4” rigid pipe. A couple of non-return valves are included
on the internal discharge pipe connection of this system.
Has been designed with a 2–1⁄ 2” vent connection on top of the enclosure. All plumbing codes require
connection to a vent system. Please note that the vent system should be a two-way air vent as air needs
to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices
is not permitted.
The Sanicubic 2VX is IP68 rated for possible submergence which eliminates any potential water
damage to internal components. It comes equipped with an external control panel as well as a visual
and audible alarm system (15 Ft long wire).
The pump discharges wastewater from several toilets, sinks, bath/showers, urinals and even washing
machines. The wastewater from other sanitary fixtures is drained into the Sanicubic 2VX via five 1–1⁄ 2”
or 4” inlets on either side of the housing and on top of the enclosure. Note that when draining waste
water into the pump through either of the side inlets, an external check valve (not supplied) has to
be installed.
Also, note that there should be a minimum 12” height difference between the base of the
Sanicubic 2 to the bottom of the shower/bathtub drain or to the base of the toilet.
ASME A112.3.4
SANICUBIC
®
2 VX Vortex
PRE-ASSEMBLED VORTEX SYSTEM
CAPABLE OF DISCHARGING
WASTEWATER FROM MULTIPLE FIXTURES
Two powerful 1.5 HP motors for absolute reliability and
efficiency. New vortex technology eliminates clogging
issues found on sewage ejector stations as it can handle
feminine hygiene products.
Smart-pump technology allows both pumps to work
simultaneously if the incoming rate is higher than the
discharge rate of the single pump. The discharge rate
increases until the condition is alleviated.
System is capable of handling multiple fixtures at the
same time as it can handle up to 250 gallons per minute.
APPLICATIONS
PUMPING DISTANCE
36 Ft
328 Ft
20 Ft
1640 Ft
CONNECTIONS
SINK
WASHING
MACHINE
BATHTUB
DISHWASHER
TOILET
LAUNDRY
SINK
SHOWER
BAR SINK
4” Pipe
2” Pipe
COMMERCIAL
58