Owner's Guide

ManualsBrandsSanitaire ManualsVacuum CleanerSC5800 Series

Please Retain

We suggest you record the model, type and serial numbers

below. They are located on the silver rating plate on your

cleaner. For prompt and complete service information, always

refer to these numbers when inquiring about service.

Model& Type___________________________

Serial No. ______________________

It is also important to keep your receipt as proof of date of

purchase.

Commercial

Vacuum Cleaner

OWNER’S GUIDE

SC5800 Series

For location of nearest Sanitaire/

Eureka Warranty Station or service

information call 1-800-800-8975.

Index

Important Information 2-4

Warranty ...................... 4

Quick Reference.......... 5

Use ........................... 6-7

Accessories ................. 7

Dust Cup/Filter ............ 8

HEPA Filter.................. 9

Brush Roll ................. 10

Brush Roll Belt .......... 10

How to Remove

Blockages ................. 11

Troubleshooting ......... 12

www.sanitairevac.com

Summary of content (12 pages)

PAGE 1
Commercial Vacuum Cleaner OWNER’S GUIDE SC5800 Series Index Important Information 2-4 Warranty ...................... 4 Quick Reference.......... 5 Use ........................... 6-7 Accessories ................. 7 Dust Cup/Filter ............ 8 HEPA Filter .................. 9 Brush Roll ................. 10 Brush Roll Belt .......... 10 How to Remove Blockages ................. 11 Troubleshooting .........
PAGE 2
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. • Do not allow to be used as a toy.
PAGE 3
CONSEILS DE SÉCURITÉ Lors de l’utilisation d’un appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: • Ne pas utiliser à l’extérieur ou sur des surfaces mouillées. • Cet appareil est muni d’un double-isolement. Utilisez uniquement des pièces de rechange identiques.
PAGE 4
SERVICING OF DOUBLE-INSULATED APPLIANCES A double-insulated appliance is marked with one or more of the following: The words “DOUBLE INSULATION” or “DOUBLE INSULATED” or the double insulation symbol (square within a square). In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added to the appliance.
PAGE 5
QUICK REFERENCE WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting. 11 12 14 13 11 1 15 11 3 2 12 4 11 13 5 6 11. Hose Retainers (4). Place hose in retainers to store hose on unit. 7 9 8 12. Electrical Cord Hooks (2). Wrap electrical cord around them to store electrical cord on unit.
PAGE 6
HOW TO ASSEMBLE CAUTION: Assemble the cleaner before using. CAUTION: Moving parts, make sure on/off switch is in off (0) position before plugging in. NOTE: Features may vary by model yet all parts assemble the same. Store Hose and Accessories Nested Wands Attach Handle CAUTION: Do not catch cord under handle. Dusting Brush 1 Grooves 2 1. From rear of cleaner, align handle with groove and slide onto cleaner. If necessary, use thumb and finger pressure to slide handle into position. 2.
PAGE 7
HOW TO USE NOTE: While using accessories, do not place cleaner on furniture or steps as the brush roll may cause damage. Place cleaner on floor with the handle in storage position. 1. To use accessories remove hose from rear of cleaner by lifting up and twisting. 1 2 2. Place desired accessory onto end of hose or wand. 1. Handle Release. Step on handle release to pull handle back to a comfortable operating position. To lower handle completely to the floor, depress handle release a second time.
PAGE 8
ROUTINE MAINTENANCE The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust cup, filters, belt, and brush roll often. We suggest emptying the dust cup after every use. NOTE: NOTE: 4. Dump debris in a waste container. When vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances, the dust cup and filters will require more frequent maintenance.
PAGE 9
ROUTINE MAINTENANCE (continued) Pre-Motor Filter How To Clean Filters Pre-Motor Filter Check the pre-motor filter each time the dust cup is emptied. Clean or replace as needed. To Clean Pre-Motor Filter 1. Remove filter centered in the bottom of the dust cup compartment. 2. Shake filter to remove excess dust. If necessary, the filter can be cleaned by vacuuming with another cleaner or washing with mild detergent. 3. Reinstall filter after completely dry. 1. Remove from cleaner. 2.
PAGE 10
PERIODIC MAINTENANCE (CONTINUED) Brush Roll The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.
PAGE 11
Problem Solving To Clear Blockages in Hose NOTE:Turn off the switch and unplug the electrical cord before clearing hose. Lower Hose Adapter Nested Wands Base Hose Hose Adapter Tabs 5. Locate lower hose adapter on the back of the cleaner. 6. Remove lower hose adapter from rear of cleaner by lifting up and twisting. 7. Check for blockages in the hose and base hose. Flexing the hose may help loosen any blockage. If no blockage is found, continue to step 8.
PAGE 12
NOTE: Turn off the switch and unplug the electrical cord before servicing. PROBLEM SOLUTION Motor will not start. Push plug securely into outlet. Try another outlet. Check circuit breaker. Motor suddenly stops. Thermal Cut Off, see Page 2. Does not clean the carpet or floor. Clean or replace the filters: Hint: If picking up fine dust, the filters may not look dirty, but a fine substance tends to reduce suction when it blocks the airflow through the filters.