Commercial Wet Pickup Vacuum Spot Cleaner Ownerʼs Guide SC6070 Series Index Important Safeguards .................... 3-5 Service Information ...........................6 Identify Parts .....................................7 Use ................................................ 8-9 Trouble Shooting .............................10 Warranty .....................................11-12 To view the repair parts list, go to www.sanitairevac.com or call 1-800-800-8975 for a copy.
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury. • Use indoors only. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. • Do not allow to be used as a toy. Close attention is necessary when used by or near children.
CONSEILS DE SÉCURITÉ IMPORTANTS Lʼutilisation dʼun appareil électrique sous-entend lʼobservation de certaines règles de sécurité élémentaires: LIRE TOUTES LES INSTRUCTIONS AVANT DʼUTILISER LʼASPIRATEUR. AVERTISSEMENT Pour réduire les risques de feu, de secousse électrique ou de blessure: • • • • • • • • • • • • • • • • • • • • • • 4 Ne laisser pas sous la pluie. Ranger à lʼintérieur. Ne pas sʼabsenter tant que lʼaspirateur est branché.
Grounding Instructions This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
GENERAL INFORMATION Automatic Suction Shut-Off NOTE: Use the vacuum in the upright position. If the cleaner should tip, the automatic suction shut-off turns off the suction. The automatic suction shut-off functions when the tank is full of liquid. As the tank fills, the ball float (inside the cage) rises until it seats itself against air inlet. This shuts off the suction causing the motor sound to become higher in pitch. When this happens, empty the tank.
IDENTIFY PARTS OF SPOT CLEANER Unpack solution hose and powercord from carton and remove spot cleaner. 1 2 3 11 4 5 7 12 6 8 9 10 13 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
HOW TO USE Fill Solution Tank CAUTION: Use only commercially available carpet and upholstery cleaners intended for machine applications. Solution tank holds 1.5 gallons. Remove solution tank lid and fill with mixture of water and extraction detergent. (Follow recommended mix ratio on extraction detergent label.) Note: Do not overfill. Attach Vacuum Hose Coupling • Push the hose coupling into the hose inlet. • Give a slight twist to secure.
HOW TO USE (continued) Begin Cleaning With the cleaning nozzle you may begin cleaning. By pulling the trigger, you will dispense the solution onto the desired area. Use a backstroke motion. Because the vacuum is on, the fluid will quickly be sucked back into the wand. Make several dry passes over the affected area to completely remove any excess moisture. You will notice that the area you have just cleaned will be damp. This is normal.
TROUBLESHOOTING SYMPTOM: Unit will not turn on. Problem: Solution: Not plugged in. Plug machine in proper outlet. Problem: Solution: Circuit breaker has popped. Reset circuit breaker. Make sure no other items are running on the same circuit as machine. Outlet must be a 20-amp circuit. Problem: Solution: Power cord has become disconnected from extension cord. Reattach power cord to extension cord. SYMPTOM: Pump is not running properly.
EUREKA SANITAIRE COMMERCIAL EQUIPMENT LIMITED WARRANTY Carpet and Spot Cleaners (Excludes Vacuums) Your equipment, which has been manufactured, tested and inspected with carefully specified engineering requirements, is warranted to be free from defects in material and workmanship.
PROCEDURE TO BE TAKEN TO OBTAIN PERFORMANCE OF LIMITED WARRANTY REPAIR To secure repair of the equipment or any warranted parts under this Limited Warranty, the following procedure should be taken. The inoperative equipment or warranted parts, together with satisfactory evidence of the purchase date, must be delivered, with shipping and delivery charges prepaid, to one of the following: 1) The dealer from whom purchased; 2) Any authorized service station.
Part No. 73681 (2/04) ©2004 White Consolidated, Ltd. Printed in U.S.A.
