Owner`s manual

15
NOTE:
It is possible to have two types of rubber blades. Para
rubberbladesforalltypesofoorsandpolyurethane
rubberbladesformechanicalworkshopoorswhichare
dirty with oil.
7.2 Squeegee set up (correct position)
(Fig. 22)
•Lowerthesqueegeeusingthesqueegeelever.
•Startthevacuumandmoveforwardseveralfeetbefore
stopping the suction unit and the machine.
•Checktheangleoftherubberblades(1)ontheoor.
Fig. A = too low
Fig. B = too high
Fig. C = correct position
•Removethesqueegeeunitfromthemachine
•Torepositiontheblade,loosenthescrew(2)ofthewheel
(3) and move the wheel vertically in the slot lifting or lower-
ing the wheel, to achieve the correct
position (C).
Fig 21
Fig 22
7.3 Changing the brush or pad driver
•Liftthemachineupslightlyatthefront
•Pressthebrushrotationbutton(3)toenabletherotation
of the brush, then press lever (5) and release it; the brush
becomes disconnected (Fig 23)
7.4 Replacing the fuses (Fig 24)
WARNING Replace the blown fuse with one
with the same amperage.
•Unscrewthetwobolts(1)thatfastentheexternalbox
(2) and remove it.
•Unscrewthetwobolts(3)oftheprintedcircuitboard
(4) and remove it.
•ReplaceFuse(5)Green30A
•Reversestepsabovetoreplacecomponentsafter
fuse is replaced.
(Fig 23)