Owner`s manual

9
To move the machine to the work area lock handle and tilt
backwardstoraisethefrontofftheoor,andwheelinto
position.
CAUTION – Bumping over thresholds,
curbs and similar obstacles can damage
the machine. Pull the machine backwards to
go over small obstacles.
1.4 Symbols & Markings
In order to highlight information and procedures regarding
safety, maintenance etc, the following symbols have been
adopted in the manual:
1.5 Electrical connection
Before connecting the machine to the power supply, check
that your supply voltage matches the rating on the machine
label.
IMPORTANT - If the battery charging lead is damaged, it
must only be replaced by an approved cord available from
the manufacturer or an authorized service agent.
WARNING – THIS APPLIANCE MUST
BE GROUNDED
2 Preparing for use
2.1 Connecting the batteries
•Unscrewtheboltsthatfastenthetanktothehandlesupport
(Fig 1).
Fig 1
•Removetherecoverywatertank(Fig2).
•Connectthebatteryconnectors(Fig3&4).
•Replacetherecoverywatertankandscrewintoplace.
WARNING Make sure that the building
power supply is equipped with GFI (circuit
breaker).
2.2 Charging the batteries
WARNING Charge batteries in a well
ventilated area which complies with local,
state and federal regulations and with
standards in force in the country of use.
•Movethemachineclosetoaelectricalsocket.
•Unwindthebatterychargingleadattherearofthe
machine and connect to the outlet.
WARNING Check that the building power
supply matches the operating voltage of the
battery charger (100 – 120V, 50/60Hz).
Fig 2
Fig 3
Fig 4