Operation Manual

8
5 Initial use
Setup
Remove the unit from the packaging. Place
it on a flat surface.
Ensure that the ventilation slits are free.
Push the lid [2] backwards to access the
accessory parts.
Before using the unit for the first time
Note:
• The atomiser and accessories must be
cleaned and disinfected before they are
used for the first time. For information
about this, see “Cleaning and disinfection”
on page 11.
• Attach the compressed-air hose [8] at
the bottom of the medicine container
[11].
• Connect the other end of the hose [8] to
the hose connector [6] on the nebuliser
by lightly turning it.
Mains connection
Connect the unit only to the mains voltage
listed on the type plate.
• Insert the mains cable plug [1] into a
suitable socket.
• Push the plug completely into the mains
socket.
Note:
• Ensure that there is a socket near to
where the unit will stand.
• Lay the mains cable in such a way that
no one can trip over it.
• To disconnect the nebuliser from the
mains after use, first switch off the device
and then remove the plug from the
socket.