Installation Guide

Cleaning and Dismantling
1. Clean the exterior of the bidet seat.
2. Clean the spray nozzles.
Pull out the nozzle softly and use smooth
cloth/sponge or toothbrush with liquid dish
soap to clean the nozzle.
Close the cover. Push the dismantle button
and pull the Saniwise Bidet Seat forward,
as shown in the figure below.
4. Dismantle the Saniwise Bidet Seat.
Use a smooth sponge/cloth with diluted
dish detergent to clean the product. Do not
use the following types: hydrogen chloride
detergent, paint thinner, benzene, abrasive
paper, polishing agent, bleach, or chlorine.
Insecticide
Abrasive paper
Paining thinner
Then pull the bidet seat
forward while pressing the
dismantle button.
Close the cover first
Filter
Braided hose
(If the water flow is less than usual)
1) Turn off the water supply, remove the
white water inlet hose, and clean the
filter screen.
2) Remove the regulator with a pair of
pliers, remove the regulator cover, and
clean the regulator O-ring.
Regulator
3. Clean the filter and regulator.
8
5