Installation Guide

9
Maintenance
6
1) Remove the old lever as shown in figure A.
2) Insert the new lever rib into the
corresponding slot. When the new lever is
mounted properly, a click will be heard.
1) Pull out the tube and hold it, then remove
the old nozzle, as shown in figure A.
2) Mount the new nozzle to the corresponding
slot on the tube. Now, the nozzle is
replaced successfully.
If water leaks from either end of the water
hose, tighten the nuts gently until the water
inlet hose stops leaking.
1) Rotate the lever forward. Remove the
regulator from the water inlet with the
needle-nose pliers.
2) Press the new regulator into the water
inlet tube.
3) Rotate the lever to the vertical position.
Now, the regulator replacement is
completed.
Regulator
1. Lever Replacement 2. Nozzle Replacement
3. Regulator Replacement 4. Repairing a Leaking Water Hose
A
B
Nozzle
A
B
C