Installation Guide

10
0.35 - 1.8 L/min
0.35 - 1.8 L/min
Issue Cause Solution
The water pressure is low
when using WASH/BIDET.
The bidet seat’s water pressure is low.
The pressure of the water supply is low.
Turn the lever forward or backward to the highest setting during use.
If the pressure of the water supply is too low, please contact your
local water department.
No water comes out
when using WASH/BIDET.
The shutoff valve is turned off.
Turn on the shutoff valve.
The T-shaped connector’s filter is stuck.
Clean the T-shaped connector’s filter.
The water inlet hose’s filter is stuck.
Clean the water inlet hose’s filter.
The nozzle head is stuck. Remove the nozzle head and clean it.
The pressure of the water supply is too low.
Increase the pressure of the water supply.
The toilet bowl is leaking
during usage.
The maximum water pressure of the Saniwise Bidet Seat is 110 PSI.
If the pressure of the water supply is higher than that, please contact
your local water department.
The pressure of the water supply is too
high.
If the failure still occurs after the solutions above have been taken, please contact Saniwise by
sending an email to [e-mail].
FB108
Model No.
Check valve and vacuum breaker
Water Supply Directly from water pipes
Water Pressure Range
Dimensions
Weight
Caution
Do not disassemble, repair, or remodel the Saniwise Bidet Seat.
Self-diagnosis and Troubleshooting
Water Flow (WASH)
Water Flow (BIDET)
Backflow Prevention
Specifications
2.09 kg
370x480x62 mm
10-110 PSI
7
Self-diagnosis and Specifications