Installation Guide

Inﬆallation Procedures

Inﬆallation Method One (Recommended)

1. Dismantle the old bidet seat and lid.

Loosen the hinge and remove the old bidet seat and lid.

Keep this side with FRONT up

Inﬆallation

template

*Butterﬂy nuts are only used for

the optional inﬆallation method two.

Inﬆallation template

Inﬆallation Method Two

1. Dismantle the old bidet seat and lid, and place the inﬆallation template on the ceramic, as described in ﬆep 1 and ﬆep 3 of the

inﬆallation method one.

2. Put the adapter plate over the toilet seat’s mounting holes in the ceramic of the connecting bolts with adjuﬆing pieces. Screw the nuts

from underneath the toilet. Then tighten them to secure the adapter plate. Refer to the ﬆep 4 of the inﬆallation method one.

3. Complete the following inﬆallation procedures, as described in ﬆep 5 and ﬆep 6 of the inﬆallation method one.

2. Inﬆall the expansion nuts.

Insert the expansion nuts into the holes of the ceramic. Be

sure to ﬁrmly press down so the top of the expansion nut is

ﬂush with the ceramic toilet surface.

3. Inﬆall the inﬆallation template.

4. Fix the adaptable panel.

Attach the adapter plate. Attach the adapter plate in the toilet

seat holes. Adjuﬆ the connecting bolts’ and adjuﬆing pieces’

position to line up the connecting bolts to the expansion nuts.

Then tighten them to secure the adapter plate.

5. Remove the inﬆallation template. 6. Mount the Saniwise Bidet Seat.

Keep the ﬁxing slots under the Saniwise Bidet Seat aiming

at the slots on the adaptable panel. Push the Saniwise Bidet

Seat to the end. Now, the Saniwise Bidet Seat is inﬆalled

successfully.

Fixing slots under the

Saniwise Bidet Seat

Bidet seat and lid

Place the inﬆallation template on the ceramic.