User manual

Chapter 4: V-Switch Configuration 51
Enter the default user name, sanrad, and password, sanrad, and press Enter
on your keyboard. The CLI prompt > appears. You are now logged in and
ready to begin configuring your V-Switch for volume virtualization and exposure.
STEP 3. INITIALIZE THE V-SWITCH
Use the CLI command init to configure the V-Switch management parameters.
init
You need to define five parameters to configure the V-Switch for the first
time:
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-n
NAME USER-ASSIGNED
NAME FOR THE
V-
S
WITCH
MANDATORY
DEFAULT:
VS
WITCH
VSwitch
-ip
MANAGEMENT IP
ADDRESS
IP
ADDRESS OF
THE MANAGEMENT
PORT
MANDATORY
212.199.43.46
-im
MANAGEMENT IP
MASK
IP M
ASK FOR THE
MANAGEMENT PORT
OPTIONAL
DEFAULT:
255.255.255.0
-p
UDP PORT PORT THROUGH
WHICH ALL
UDP
COMMUNICATIONS
WILL FLOW
–
NAMELY FOR SNMP
OPTIONAL
DEFAULT: 161
-if
INTERFACE ALIAS ALIAS OF PORT FOR
MANAGING V-
S
WITCH
OPTIONAL
DEFAULT: MGMT
(ETH1 OR
MGMT)
Example:
init –n VSwitch –ip 212.199.43.46
After the V-Switch is initialized, this CLI command will disappear from the
CLI menu.