User's Guide

App installation
Search “Stellar BLE” in Google Store or App Store to get the App.
Note：If it has been installed on the phone, make sure the app is the latest version.
Add devices
1. Turn on the light after the installation.
2. Open the Stellar BLE App, make sure the Bluetooth on your phone is on, get the phone close to
the device.
3. Tap “+” on the top right of the “Light” interface, tap “Add Devices” to start searching devices.
After the device is displayed on the list, select the device, tap “NEXT” to continue.
4. Wait for the device connection, ensure it has been added successfully, tap “OK” to finish.
Note: Retry it several times if adding failed due to connection error.
Restore factory settings
You can select “Disconnect” on the Light Information interface, then select Remove, the device
will be reset successfully after it blinks to constant white light(idle state).
Technical Parameters
Product Name: Smart LED grow light
Model: C3ZW005-B0010A27
Input: AC 120V, 60Hz
Rated Power: 10W
Beam Angle: 60°
IP Degree: IP20
Control Method: Mobile App
Lamp holder Type: E26
Lifespan: 25000 hours
Product Dimensions: 62*62*84mm
Working Temperature: -10℃~-40℃
Cautions:
1. Read the instruction manual thoroughly before first use. Follow all the safety instructions and
information.
2. This product is suitable for indoor plant cultivating scenarios like vertical farms, plant factory,
plant incubator, greenhouse, etc.
3. Risk of burn! Do not touch LED light source or the housing during use.
4. Ensure the voltage given on the rating label / in the user guide complies with the power
supply.
5. Do not stare at the operating light source or direct the beam at other people or animals to
prevent eye damage.
6. Install the product according to the intended use and as described in this manual.