Operation Manual

24
Cinema Wide1 picture size (for 4:3 format
programs)
To fill the screen, the right and left edges are
extended,
however; the center of the picture remains near its
former ratio.
The top and bottom edges of the picture may be
hidden.
Cinema Wide2 picture size (for letter box
programs)
The entire picture is uniformly enlarged—it is
stretched the same amount both wider and taller
(retains its original proportion).
The top and bottom edges of the picture may be
hidden.
A B C D E F G - - - - - - - - - - - - - - - -
Cinema Wide3 picture size (for letter box
programs with subtitles)
To fill the width of the screen, it is extended
horizontally. However; it is only slightly extended at the
top and the bottom.
The top and bottom edges of the picture may be
hidden.
A B C D E F G - - - - - - - - - - - - - - - -
A B C D E F G - - - - - - - - - - - - - - - - - - - - - - - - - -
Full picture size (for 16:9 source programs)
Full will display the picture at the maximum size.
NOTE:
Some High Definition and/or Digital broadcasts may
not allow you to change the picture size.
In HDMI or COMPONENT mode with a scanning
rate of 720p or 1080i, only the Cinema Wide2 and
Full picture size features are available.
In PC Mode, only the Natural and Full picture size
features are available.
In Cinema Wide2 picture size, some of the on
screen display items may be positioned off the
visible portion of the screen.
•
•
•
•
Film Mode
A smoother motion may be obtained by setting
the Film Mode to “On” when you view a DVD from
the DVD player connected with the component
input.
1
Press MENU. The menu screen will appear.
2
Press ▲ or ▼ to select “Picture”, then press ▶ or
ENTER.
3
Press ▲ or ▼ to select “Film Mode”.
Press ◀ or ▶ to select “On” or “Off”.
PC Setting >>
DNR On
Picture
Picture Setting >>
Picture Preference Sports
Picture Size >>
Film Mode On
: Adjust
: Select
4
Press EXIT to return to the normal screen.
Picture control
adjustment in the PC mode
You can adjust to optimize the performance of
the TV in the PC mode.
1
Press INPUT SELECT, then press ▲/▼ or
Number button (6) to select the PC mode.
2
Press MENU. Then press ▲ or ▼ to select
“Picture” , then press ▶ or ENTER.
3
Press ▲ or ▼ to select “PC Setting”, then press ▶
or ENTER.
Ver Position
Clock
Phase
: Adjust
25
0
25
PC Setting
Hor Position
25
: Select ENTER:Set
4
Press ▲ or ▼ to select the desired item you want
to adjust.
5
Press ◀ or ▶ to adjust the setting.
Hor
Position:
To adjust the horizontal position of
the image on the Component or PC
mode.
Ver
Position:
To adjust the vertical position of the
image on the Component or PC
mode.
Clock: To minimize any vertical bars
or stripes visible on the screen
background.
Phase: This must be adjusted after the
frequency of the Component or
PC mode has been set to 60Hz to
optimize picture quality (page 16).
34D0101A_eng.indd 2434D0101A_eng.indd 24 12/7/07 2:30:21 PM12/7/07 2:30:21 PM