- Orion America Inc. DVD VCR Combo User Manual

Auto clock setting / Setting the video channel
Auto clock setting
Preparation:
You must set the antenna connection before the AC cord plug is in-
serted into the AC outlet.
WAiT 30 MINUTES when the power switch is off, after the connections
of the antenna and the power plug, because the auto clock setting
feature is activated.
After the clock is set automatically, you may have to set the time zone
and daylight saving time. (See page 2&}
Press POWER to turn on the DVDiVOR after the auto clock operation
completed.
• When shipped from factory, the "AUTO CLOOK" option is set to "ON"
position.
• if you turn the DVDiVOR on during auto clock setting, the clock is not
set.
• After a power failure or disconnection of the power plug, the clock will
be lost. In this case, wait 30 minutes before turning the DVDiVOR on.
• With cabfe box connection, if the auto clock setting is unsuccessful,
select the PBS channel carrying the XDS information, then turn the
DVDfVOR off. After 30 minutes, turn the DVDfVCR on.
• If the clock is not set automaticaUy, set the cfeck manuaUy. (See page
26.)
Setting the video channel
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be
set to channel 3 or 4 (video channel).
When a TV is connected with the 75 ohm coaxial cable only:
Press and hold 3 4 the remote control for 3 seconds in the
or on
standby mode to sefect OH 3 or 4, The sefected channel number
will flash on the display for about 4 seconds.
Turn ON the TV and OH 4 with the chan-
set to 3
or
to
correspond
nel selected in step 1.
Press POWER to turn on the DVDFv'CR.
NOTES:
• When shipped from factory, the
video channel is set to CH 3.
• If the unit does not operate prop-
erly, or No key operation (by the
unit and!or the remote control):
Static electricity, etc., may affect
the operation. Disconnect the AO
power cord once, then connect it
again.
PressTV/VCR toselect the VCR
position.
The VCR indicator will appear in the display.
Select channel to receive TV station in
any
a
your
area.
The channel number will appear on the screen for about 4 sec-
onds.
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot be tuned on
your TV, proceed as follows: set the VCR 3/4 channel selector and the
TV to CH 3 or 4, playback a prerecorded tape and tune the TV to re-
ceive a sharp color picture from the video cassette recorder. Refer to
your TV owner's manual for details.
22
VRDVD4005 P23-P32 22 03.9._0, 2_5 PM