Specifications

SBIG STF-8300 Manual

9. If for some reason the Add New Hardware Wizard asks you to

manually locate the drivers then navigate to the proper directory under

the Driver Checker directory in the Program Files or Program Files

(X86) directory. There are 4 possibilities and you must choose the

correct set of drivers. There are directories for 32 Bit and 64 Bit

drivers, based upon you version of Windows and under them

directories for Classic and Pro model cameras. For non-ST (round

body) cameras, pick either classic or Pro, it does not matter which).

10. At this point the fan in the camera should come on and the camera

should show up in the Device Manager as shown below:

11. Run CCDOps and verify that you can establish a link to the camera.

Note: If you previously installed SBIG 32-bit drivers using the old 32-

bit Driver Checker program and now want to install 64-bit drivers

over the old installation, follow the procedure outlined below:

Migrating Old Drivers from 32-bit to newer 64-bit Systems

This section describes how to migrate drivers from the old 32-bit only

DriverChecker to the new 32/64-Bit Compatible DriverChecker64.

1. Uninstall the old DriverChecker software.

a. Run the Add or Remove Programs Control Panel in the

Start menu.

b. Click on the SBIG Driver Checker entry and then click

on the Change/Remove button.

2. Manually delete the old drivers files from the disk.

a. Delete the following files from the

C:\Windows\System32\Drivers directory:

sbigfldr.sys, sbiguldr.sys, sbiglldr.sys, sbigusbe.sys,

sbigusbi.sys