Use and Care Guide

Use as directed. To ensure proper performance, please be sure to contact us if you have installation or operation questions.
ENVIROLET®/SG INSTALLATION & OPERATION MANUAL (7MINS11D 12.15) • Envirolet® is a registered trademark. ©2016, Sancor Industries Ltd.
43
Ø “B” - Below Floor (with right-angle fitting)
• Envirolet FlushSmart VF700 Series models include VF700 toilet and floor mounting cup kit.
• Position and install floor-mounting kit to floor position and install toilet to floor mounting kit.
• Make sure rubber “O”-ring around base of VF700 toilet is well lubricated with silicone grease and insert toilet base carefully in
floor mounting cup to prevent pinching or damage “O”-ring.
• Connect right-angle fitting to back of straight fitting that exits from back of toilet using CPVC solvent-cement to
ensure tight fit. Failure to solvent-cement plastic fittings will cause loss of vacuum and vacuum pump to run continuously.
IMPORTANT
The “A” - Above Floor Rear (straight fitting) or “B” - Below Floor (with right-angle fitting) plastic fitting
must be solvent-cemented with CPVC into back of VF700 toilet drain outlet fitting located at rear
bottom center of VF700 toilet.
Note:
Use service switch on back of VF700 toilet to open and close bowl trap for service use.
WALL MOUNTED SWITCH (VF700 SERIES ONLY)
A. GREEN LIGHT: INDICATES READY TO FLUSH
B. RED LIGHT: DO NOT FLUSH
Switch Operation
A. Push green switch button to flush toilet.
B. Red light turns on between flushes and vacuum generator starts, runs and shuts off on green light (approx 40 seconds)
VF300 Series A & B Models
VF300 Series models are manual pedal-flush.
VF300 A & B Series
Ø “A” - Above Floor Rear (straight fitting)
or
Ø “B” - Below Floor (with right-angle fitting)
VF300 “A” Above Floor Rear (straight fitting)
A. The “A” model uses a direct toilet to 1.5” flex drain hose connection.
B. Position and install “A” - Above Floor Rear model toilet in bathroom.
C. Apply included lubricant to inside of 1.5” flex drain hose and outside fittings to allow for easier connection.
D. Use 2 x Gear Clamps for tight fit. It is essential that 2 be used. Each Gear Clamp should be installed with the tightening-
screw directly opposite the other (12 o’clock and 6 o’clock) to ensure tight connection and proper vacuum seal.
E. Do not use solvent-cement (CPVC) on VF300 “A” models.
VF300 “B” - Below Floor (with right-angle fitting)
A. The “B” model rear-below floor uses below floor cup.