Use and Care Guide

Table Of Contents

Use as directed. To ensure proper performance, please be sure to contact us if you have installation or operation questions.

How to Empty

1. Check System

Before emptying, check inside Composting Unit through the toilet seat (Waterless Self-Contained

models) or service panel (Waterless Remote, Low Water Remote or FlushSmart VF models) for

wetness.

Please follow empty wait time recommendations before emptying (discussed in previous

section).

If the mass inside your Envirolet®/SG Composting Unit still appears very wet, add as much Daily Mix

(or peat moss) as needed to absorb the excess moisture and allow more time for evaporation prior

to emptying the compost.

2. Remove Bottom

Panel

To empty your Envirolet®/SG it is necessary to remove the Bottom Panel for access to the soil

collecting tray. (You may also need to remove the Bottom Panel to clean or inspect your 2-Stage

pre-sediment filter.)

OUTER KNOBS

Turn the 2 outer knobs on the Bottom Panel counter-clockwise until they are completely removed.

INNER KNOBS

Loosen the 2 inner knobs on the Bottom Panel counter-clockwise. It is best not to remove the inner

knobs completely.

With the 2 inner knobs still attached, but loose, push with your thumbs on the inner knobs to bring

the plastic Bottom Panel towards yourself until it rests flush with knobs. Lower the panel downward

slightly to bring the metal Back Plate through the opening in the system. Your Bottom Panel should

now be removed.

NOTE FOR LATER RE-ATTACHMENT

Take note of label on Metal Back Plate and re-install in same position when re-attaching. Back Plate

“This Way Up” label: